744523
31
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
31
DK ENG
Please note that no unauthorised alterations of the design may be undertaken, and that any
parts that are replaced must be replaced with original Morsø parts.
Gaskets
The gaskets in the doors will wear out over time and should be replaced as required in order to
prevent runaway combustion. Use the original Morsø gasket kit.
Note: Normal wearing parts are not covered by Morsø’s extended warranty.
A selection of maintenance products (spare parts, glass cleaner, paint, gasket kit, etc.) is avail-
able from your Morsø dealer.
3.3 Cleaning the stove
A layer of ash and soot will form as a result of the draught in the chimney and after sweeping,
particularly on the top of the upper baffle.
During normal cleaning, the baffles can be removed from the stove. Once the baffles have been
taken out, you can access the flue chamber above the baffles and clean it.
Clean the baffles before reassembling them, and make sure that they are correctly assembled.
Nowadays, the chimney sweep must remove the soot in the stove, in addition to sweeping the
chimney and cleaning the flue pipe. The number of annual sweepings/cleanings of the stove
should be determined in consultation with your chimney sweep.
Ash
As noted above, there should be a layer of approx. 1 cm insulating ash in the bottom of the
combustion chamber in order to achieve a high combustion temperature. If the layer of ash is
too thick, it can be brushed down into the ash pan.
Empty the ash pan before it gets completely full so that the ash does not insulate around the
grate, and thereby speed up the burn-through.
In most cases, the ash will need to be taken away by the waste disposal company. Because em-
bers may be concealed in the ash pan for several days, it may be necessary to store the ash in a
container made of non-flammable material before pouring it into a rubbish bag.
Ash from a wood-burning stove will not be of any benefit to your garden as fertiliser. If you have
burned colour brochures, or painted or treated wood, etc., in the stove, the resulting ash must
not be poured onto soil as it may contain heavy metals.
Removing/installing vermiculite parts (brick panel, rear
brick and baffle plates)
Vermiculite should only be removed/installed when the sto-
ve is cold
1. Start by removing ash from the cold stove.
31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Morso S50-40 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info