Bedienungsanleitung Motorola D1111 (Seite 37 von 43) (Englisch)

458252

Zoom out

Zoom in

Vorherige Seite

1/43

Nächste Seite

Help 37

15. Help

Phone does not work

• Have you installed the batteries correctly?

• Check that the mains power is correctly connected.

No dial tone

• Is the telephone cord of the base plugged into the phone socket?

• Check that the mains power is correctly connected to the base and to

the handset charger(s).

• Only use the telephone cord supplied with the phone.

Cannot dial out or receive calls

• Check that the mains power is correctly connected.

• The batteries may need recharging.

• Has there been a power cut? If so, place the handset back on the base

for 10 seconds and try again. If it still does not work disconnect the

batteries and mains power for 10 minutes, then reconnect and try again.

You have a dial tone, but the phone will not dial out

• You may need to change the dial mode from tone to pulse, see

page 19.

• If you are connected to a switchboard, check whether you need to dial

an access code.

Handset does not ring

• The ringer volume may be switched off, see page 17.

• Check that the mains power is correctly connected.

• Check that the line cord is connected.

• Make sure the handset is registered to the base, see page 36.

No display

• The batteries may be flat, dead or incorrectly inserted. Recharge or

replace the batteries.

icon flashes

• Is the handset registered correctly to the base, see page 36.

• Check that the mains power is correctly connected.

• Check that the handset is within range of the base.

• The batteries are low, place the handset on the base/charger to

recharge.

icon not scrolling

• Try cleaning the charging contacts.

• Check that the mains power is correctly connected.

You hear the busy tone when you press

• Make sure the handset is in range of the base.

• Another handset registered to your D1111 base may be on the line.

Answer machine does not record any messages

• The memory may be full. Play and delete old messages, see page 29.

Answer machine messages have the wrong date and time

• Have you set the date and time? See page 21.

No Caller Display number/name displayed

• Have you subscribed to a Caller Display service from your network

provider? See page 24.

• The caller may have withheld their number.

• An exact name/number match was not found in your directory. Check

that you have stored the full STD dialling code.

Cannot register a handset to a base

• You can register a total of 5 handsets to your D1111 base and you can

exceeded the limits.

• Check that you have entered the correct PIN number (default PIN

0000).

• Check that you are at least one metre away from other electrical

equipment to avoid interference when registering.

Base unit does not ring

• Have you connected the telephone line correctly?

• Is the base ringer set to off?

• You may have a faulty line or socket. Try using another socket or line.

Buzzing noise on my phone or on other electrical equipment nearby

• Sometimes your D1111 can interfere with other electrical equipment if

it is placed too close. It is recommended that you place your D1111 at

least one metre away from electrical appliances or metal obstructions

to avoid any risk of interference.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Motorola D1111 Seite 37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Motorola D1111

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info