4
Store your iron
• Set the steam control to and unplug the iron.
• Wait until the soleplate cools down and empty the reservoir. A
little water may remain in the reservoir.
• To wind the cord around the heel of the iron, slot the Easycord
system into the notch (fig.11). Take the end of the Easycord
system and press to make the flexible part go back into the base
(fig.12). Wind the cord.
• Store the cold iron on its heel (fig.13).
Obtain more steam (depending on model)
• Press the Boost button now and again to remove stubborn
creases (fig.8).
Wait a few seconds
between each shot before
pressing the button again.
Vertical steam ironing (depending on model)
Ideal for removing creases in suits, jackets, skirts, curtains, etc.:
• Hang the garment on a hanger and hold the fabric slightly taut
with one hand.
• Set the thermostat control to MAX (fig.5).
• Press the Boost button repeatedly (fig.8) moving the iron
from top to bottom (fig.10).
• Hold the iron a few centimetres from the fabric to avoid burning
delicate fabrics.
Every fifth time you press
the button, return the iron
to the horizontal position.
The steam is very hot, so
you should always do this
with the garment on a
hanger – never while
someone is wearing it.
Spray Function
• Whether steam or dry ironing, you are able to use the Spray
button (fig.9) to dampen laundry to remove stubborn crea-
ses.
In order to avoid water
dripping from the iron
onto the linen:
- turn off the steam when
ironing silk or synthetic
fabrics.
- set it at the minimum
position for wool.
If you turn down the ther-
mostat, wait until the
thermostat light comes
back on before beginning
to iron again. When
ironing fabrics with mixed
fibres, set the ironing
temperature for the most
delicate fibre. For delicate
fabrics we recommend
testing the fabric first on
an inconspicious place eg
(inside the hem).
If you want to dry iron, set
the Steam control to
.
F
ABRIC
P
OSITION OF
THERMOSTAT CURSOR
LINEN MAX
C
OTTON
•••
WOOL
••
SILK
•
S
YNTHETIC
(Polyester, Acetat,
Acrylic, Nylon)
• Set the steam control (fig.7) to the desired position,
consulting the table below.
= STEAM ZONE
• Your iron heats up quickly : so begin by ironing fabrics that
are ironed at low temperatures first, then go on to those
requiring a higher temperature.
S
TEAM SETTING
POSITION
