USING THE APPLIANCE
• Place the juice collector (E) on the body of the appliance (see Fig. 1).
• Place the sieve (D) in the juice collector (E). Ensure that the sieve is properly
clipped onto the drive shaft (J). You can hear an audible click when the sieve
is positioned correctly (see Fig. 2).
• Fit the pulp collector (G) on the rear of the appliance (see Fig. 3).
• Fit the cover (C) on the appliance, spout to the rear (see Fig. 4).
• Push the safety clamp (H) to the rear until it locks into place. You will hear an
audible “click” (see Fig. 5).
• Slide the pusher (A) into the feed tube (B) aligning the groove on the pusher
with the small ridge in the feed tube.
• The juice jug cover (L) has a foam separator that keeps the foam in the jug
(M) when you pour the juice into a glass. If you do not want to separate the
foam, remove the cover.
• Place the juice jug (M) under the pouring spout in front of the appliance (see
Fig. 6).
• Plug in the appliance.
• To start the appliance, use the control switch (I).
• Insert the fruits or vegetables through the feed tube (B).
• The fruits and vegetables must be inserted only while the motor is running.
• Do not press too hard on the pusher (A). Do not use any other utensil. NEVER
push with your fingers.
• When you have finished, stop the appliance by turning the control switch (I)
to 0 and wait until the sieve (D) stops completely.
• When the pulp collector (G) is full, or the juice flow slows down, empty the
pulp collector and clean the sieve and the cover.
8
