USING THE APPLIANCE
• Fit the juice collector ( ) in the appliance, tipping it slightly forward to pass
the pouring spout through the hole provided (see ).
• Place the sieve ( ) in the juice collector ( ). Ensure that the sieve is properly
clipped onto the drive shaft ( ). You can hear an audible click when the
sieve is positioned correctly (see ).
• Fit the cover ( ) on the appliance, ejection spout to the rear (see ).
• Push the safety clamp ( ) to the rear until it locks into place. You will hear an
audible “ ” (see ).
• Fit the pulp collector ( ) on the rear of the appliance (see ).
• Slide the pusher ( ) into the feed tube ( ) aligning the groove on the pusher
with the small ridge in the feed tube.
• If you wish to separate the juice from the froth, slide the foam separator ( )
in the juice jug ( ) and fit the cover onto the jug (see ). The foam
separator allows you to keep the froth inside the jug when you pour the juice
into a glass.
• This appliance is fitted with a drip-stop system ( ): push the pouring spout
down to actuate the system and allow the juice to flow out (see )
• Place the juice jug ( ) under the pouring spout in front of the appliance
(see ).
• Plug in the appliance.
• To start the appliance, use the control switch ( ).
• Insert the fruits or vegetables through the feed tube ( ).
• The fruits and vegetables must be inserted only while the motor is running.
• Do not press too hard on the pusher ( ). Do not use any other utensil. NEVER
push with your fingers.
• When you have finished, stop the appliance by turning the control switch ( )
to 0 and wait until the sieve ( ) stops completely.
• When the pulp collector ( ) is full, or the juice flow slows down, empty the
pulp collector and clean the sieve and the cover.
•
After making your juice, activate the drip-stop system by pushing the pouring
spout up before removing your glass to stop the flow of the juice (see ).
