659263
18
Zoom out
Zoom in
Vorherige Seite
1/118
Nächste Seite
17
EN
Do not put liquid or any ingredients in the blender bowl where the temperature exceeds 60°
C (140°F) in the blender bowl.
Put the lid (D6) on the bowl (D4), lock the cap (D7) in its housing situated on the lid.
Fit the assembled bowl (D) on the motor unit (A), with click button (D2) of the blade unit aligned
with the notch situated on the front of the motor unit (A) ( fig. 3). The bowl (D) must be pushed
down far enough on the motor unit (A) or the appliance will not work (fig. 4).
Accessories:
With the "click" button (E2) or (F2) of the blade unit (E1) or (F1) in front of you, place the
base of the bowl (E4) or (F4) under the rib (E3) or (F3) (fig. 5a) and then bring back the blade
unit (E1) or (F1) to the bowl (fig. 5b), lock by pressing the "click" button (E2) or (F2) and
then release it. . Make sure that the bowl (E4) or (F4) and the blade unit (E1) or (F1) are well
connected (fig 5c).
Check whether there is no error in the assembly of the accessories (E) and (F): the colour of the click
button (E2 or F2) must correspond to the colour of the line on the base of the bowl (E4 or F4).
Place the assembled accessory (E) or (F) on the motor unit (A). The click button (E2) or (F2)
must be in front of you. Push it until the marking is no longer visible, otherwise the appliance will
not work (fig. 6).
Blender:
Plug in the appliance and press on the button 1 (C) or 2 (B), depending on the required speed,
pressing several times for pulse operation or holding down for continuous operation. Do not run
for more than 60 seconds.
To stop the appliance, release the pressure on the button (B) or (C) unplug the appliance.
Remove the bowl (D) from the motor unit (A).
Accessories:
Plug in the appliance. Put the ingredients into the bowl (E4) or (F4).
Keep your hand supporting the bowl (E4) or (F4) and during operation press on button (B) or
(C) several times in short pulses (fig 7).
To stop the appliance, release button (B) or (C). Unplug the appliance.
Remove the accessory (E) or (F) from the motor unit (A), turn over the accessory on the work
surface and release the blade unit (E1) or (F1) by pressing on the "click" button (E2) or (F2).
You can then take out your preparation.
The lid (G) can be fitted on the bowl (E4) or (F4) to avoid preparations from drying out and also
allows them to be kept in the refrigerator for later use.
Blender :
The Blender (D) in yellow colour allows you to make liquid preparations in a few moments.
In order to facilitate the mixing, make sure to add the liquid properly.
USING YOUR APPLIANCE
USING THE ACCESSORIES
Ingredients Quantity (max) functioning time
Apple juice : apple + water 300 g + 100 g 10 sec speed 2
Banana juice : banana + water 300 g + 100 g 10 sec speed 2
Crushed ice 5 cubes 10 pulses speed 2
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Moulinex LM142A26 Fruit Sensation wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info