Bedienungsanleitung Moulinex MO4013 ZELIO (Seite 12 von 50) (Englisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch)

535319

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

CLEANING AND MAINTENANCE

1. CHANGING THE BAG

• The bag capacity indicator (5) tells you

when the bag is full or saturated.

If you notice that your vacuum cleaner is

less efficient, select the maximum power

and by lifting the floor head off the floor. If

the indicator remains red, replace the

bag.

• Open the lid (9) of your vacuum cleaner -

fig. 13.

• Withdraw the bag support (16) - fig. 14;

Unclip the bag (18) by pressing the lever -

fig. 15, and dispose of the bag in a waste

bin - fig. 16.

• Fit a fresh bag, position it using the tongue

provided and clip it onto the bag support

- fig. 17. Slide the bag support back onto

the runners - fig. 18 place the bag inside

the compartment - fig. 19.

• Make sure that the bag is in the correct

position before closing the lid (9).

CLEANING THE FOAM FILTER FOR PROTECTION

OF THE MOTOR

• The motor foam-filter protection (12) must

always be in place when in use.

• Open the lid (9). The grid (13) - fig. 20

then remove the foam-filter (12) - fig. 21.

• Shake it and clean it, every ten dustbag

changes, with tepid soapy water.

• Rinse, dry and put it back in place.

• Let the foam-filter dry (12) completely

before putting back in place.

Caution : N.B. Make sure that the foam filter

is completely dry before fitting it again.

3.CHANGE THE HEPA* FILTER CASSETTE OR THE

MICROFILTER

* ON EVERY TENTH CHANGE OF

BAG

3.1- The Hepa* filter cassette

• Open the lid (9) of your vacuum cleaner -

fig. 13.

• Remove the Hepa* filter cassette (14) -

fig. 22 and dispose of the cassette in a

waste bin.

• Fit the new Hepa* filter cassette

(ref. MT0001 01) (14) in its compartment -

fig. 23.

• Check that the Hepa* filter cassette (14) is

fitted correctly before re-closing the lid (9).

3.2- The microfilter cassette*

• Open the lid (9) of your vacuum cleaner -

fig. 13.

•

Withdraw the microfilter cassette* (15) -

fig. 22.

• Separate the grey foam filter (15b) from

the microfilter (15a).

• Dispose of the microfilter (15a) in a waste

bin and replace it with a new Microfilter

(ref. MT0001 01).

• Wash the grey foam filter (15b) with warm

soapy water (mild detergent). Squeeze it

out and leave it to dry for at least 12 hours.

Caution: Make sure that the grey foam

filter is completely dry before putting it

back in place.

• Re-fit the grey foam filter (15b) to the

microfilter (15a).

• Re-fit the microfilter cassette* in its

compartment (15) - fig. 23.

• Check that the microfilter cassette* (15) is

fitted correctly before re-closing the lid (9).

4. CLEAN THE VACUUM CLEANER

• Clean the housing of the vacuum cleaner

with a soft and humid rag and let dry.

• Clean the cover with a dry rag - fig. 24.

• Do not use abrasive or aggressive

products.

NoticeZÉLIO 7/06/07 14:43 Page 11

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Moulinex MO4013 ZELIO Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info