Bedienungsanleitung Mountfield 4155H (Seite 10 von 86) (Deutsch, Englisch, Holländisch, Französisch)

765491

Zoom out

Zoom in

Vorherige Seite

1/86

Nächste Seite

ENGLISH

3 ASSEMBLY

To avoid injury and damage to people

and property, do not use the machine

until all the measures in this instruction

have been carried out..

3.1 ACCESSORIES BAG

The machine is supplied with a plastic bag

containing components which shall be used during

the assembly. The bag contains (fig. 1):

Pos. No. Designation Dimension

A1 Key

B 1 Spare key

C 2 Tension pin 6 x 36

D 1 Shim washer 16 x 38 x 0.5

E 1 Shim washer 16 x 38 x 1.0

F 2 Shoulder washer

G2 Screw 8 x 20

H 2 Screw knob

I 4 Washer 8.4 x 24 x 1.5

J 1 Drawing plate

K4 Screw 8 x 20

L2Nut

M 2 Screw for battery

N 2 Nut for battery

3.2 ENGINE CASING (3:L)

To fill with fuel and to inspect and maintain the

engine and battery, open the engine casing.

The engine must not be running when

the casing is opened.

3.2.1 Opening

1. Raise the seat lock (2:S) and fold the seat

forwards.

2. Pull up the rubber strap at the front edge of the

casing (3:M).

3. Grasp the front edge of the engine casing and

fold up the casing (fig. 4).

3.2.2 Closing

1. Grasp the front edge of the engine casing and

fold down the casing (fig. 4).

2. Secure the front edge of the casing with the

rubber strap (3:M).

The machine may not be operated

unless the engine casing is closed and

locked. Risk of burns and crushing

injuries.

3.3 BATTERY

Do not short circuit the battery’s

terminals. Sparks occur which can

result in fire. Do not wear metal

jewellery which can come into contact

with the battery terminals.

In the event of damage to the battery

casing, cover, terminals or damage to

the strip covering the valves, the

battery should be replaced.

The battery is a valve-regulated battery with 12 V

nominal voltage. The battery fluid does not need to

and cannot be checked or topped up. The only

maintenance that is required is charging, for

example after extended storage.

After charging the battery must be stored in a cool

place.

The battery must be fully charged

before being used for the first time. The

battery must always be stored fully

charged. If the battery is stored while

discharged, serious damage will occur.

3.3.1 Charging with the engine

The battery can be charged using the engine’s

generator as follows:

1. Install the battery in the machine as shown

below.

2. Place the machine outdoors or install an

extraction device for the exhaust fumes.

3. Start the engine according to the instructions in

the user guide.

4. Allow the engine to run continuously for 45

minutes.

5. Stop the engine. The battery will now be fully

charged.

3.3.2 Charging using battery charger

When charging using a battery charger, a battery

charger with constant voltage must be used.

Contact your dealer to purchase a battery charger

with constant voltage.

The battery can be damaged if a standard type

battery charger is used.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mountfield 4155H Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info