Bedienungsanleitung Mr Coffee ES11 (Seite 13 von 36) (Englisch, Spanisch)

646244

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

1312

Brewing Coffee

If the clock display is flashing, refer to Section “Setting the Clock” before

continuing.

1. Open the swing-out brew basket to your left. Insert a MR. COFFEE

filter into

the removable black inner brew basket.

2. Add desired amount of coffee, referring to the Coffee Measurement Chart.

Shake lightly to level coffee.

3. Be sure the paper filter is centered before closing the brew basket.

4. Fill the decanter with cold water to desired capacity as marked on the side

of the decanter. (1 cup = 5 oz).

5. Pour water into your carafe. Note: For easy and accurate filling, please refer to

cup size markings located on the carafe. Pour the water into the water reservoir

and then place the empty carafe onto the warmer plate.

6. Turn your Coffeemaker switch to ON. When the coffee stops flowing, the

brewing cycle is complete.

7. Carefully remove the black inner brew basket and discard the used grounds

and filter. Rinse the black brew basket and replace. Note: Remove decanter

from the warming plate before opening the swivel basket. This will prevent

the drip stop valve from catching on the decanter lid.

8. To make another pot of coffee, repeat Steps 1 – 7.

9. Turn your Coffeemaker off when the decanter is empty.

Warning: To avoid risk of personal injury or damage to property as a result of

overflow, be sure the decanter is squarely centered under the brew

basket during the brewing cycle. Brewed coffee and grounds, both

in brew basket and decanter, are very hot. Handle with care to avoid

scalding. If brew basket overflows, or if brew basket fails to drain

into decanter during brew cycle, do not open or handle basket.

Unplug Coffeemaker and wait for contents to cool before handling.

Important: Resetting Delay Brew at the Pre-Set Time

Due to a safety feature included in this unit, the programmable timer will not

automatically brew the next day after its last use. If the Delay Indicator Light in

the lower left hand corner of the clock display is not illuminated, then you will

need to reset the DELAY BREW feature by pressing the DELAY BREW button.

The programmable timer will not automatically brew the next day if left in the

AUTO position after its last use. This is a safety feature. If the OFF indicator light in

the lower right hand corner of the clock display is illuminated, reset AUTO BREW

by turning the control switch to OFF, then to AUTO. (Models ESX20, ESX23,

ESX20D, ESX23D Only)

Setting Clock and Timer

(Programmable Models Only)

Note: You do not have to set your clock before the Coffeemaker will operate.

Plug in the power cord, press SELECT once to turn the Coffeemaker on. The ON

light will illuminate and the clock will stop flashing, but it will not keep time.

Setting the Clock

1. Plug the power cord into your electrical outlet. The clock display will flash

until you set the time.

2. Alternately press and hold the HOUR and MINUTE buttons until you reach

the current time.

3. The PM indicator light in the display will illuminate to indicate PM time.

Presetting the Brewing Time

1. You must first set the clock to the correct time before setting the desired time

for Delay Brew.

2. Press the SET/DELAY button, then alternately press the HOUR and MINUTE

buttons to set the time you want the Coffeemaker to start brewing.

The Delay Indicator Light will flash during this time.

3. Press the SET/DELAY button again to turn off the flashing light. If the

Delay Indicator Light is not flashing, pressing the HOUR or MINUTE buttons

will change the clock time.

Brewing Automatically at the Preset Time

1. Follow Steps 1 – 5 in the “Brewing” Section.

2. Press the SELECT button. The Delay Indicator Light should illuminate.

3. Brewing will begin at the preset time. The coffee will remain hot in

the decanter for 2 hours. To keep your coffee hot for an additional 2 hours,

press the SELECT button. The ON indicator light should illuminate.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mr Coffee ES11 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info