629101
18
Zoom out
Zoom in
Vorherige Seite
1/18
Nächste Seite
Operating Manual English
15
Information about the
engine
The engine manufacturer is liable
for all engine-related problems with
respect to power, power measure-
ment, technical specifications,
warranty and service. Information
can be found in the owner’s/user
handbook supplied separately by
the engine manufacturer.
Troubleshooting
Danger
Injury hazard if engine is started
inadvertently
Protect yourself against injury.
Before carrying out any work on the
mower
switch off the engine,
withdraw the ignition key,
lock the parking brake.
wait until all moving parts have
come to rest and the engine has
fully cooled,
pull off the cap of the spark plug
so that the engine cannot
inadvertently start.
Problems that occur while you are
using the mower are often caused
by something simple which you will
probably be able to rectify yourself.
If you are in any doubt however,
your dealer will be most pleased
provide assistance.
Problem Possible cause(s) Remedy
Starter does not turn. Safety interlock system has actuated. To start the engine, sit on the driver’s seat,
fully depress brake pedal or apply parking
brake.
Switch off PTO.
Battery not connected correctly. Connect red cable to (+) battery terminal and
black cable to (–) battery terminal.
Discharged or low battery. Check the battery, charge it or exchange it.
Fuse has tripped. Replace fuse. If the fuse trips repeatedly,
look for the cause (usually short-circuit).
Loose earth cable between engine
and frame.
Connect earth cable.
Starter turns but engine
does not start.
Choke and throttle in wrong position. Actuate choke. Move throttle to .
Carburettor not receiving any fuel,
fuel tank empty.
Top up with fuel.
Defective or dirty spark plug. Check spark plug; see engine manual.
No ignition spark. Have ignition checked in repair shop.
Engine emits smoke. Too much oil in engine. Switch off engine immediately.
Check engine oil level.
Engine defective. Switch off engine immediately.
Arrange for service agent to check
the engine.
Excessive vibration. Damaged blade drive shaft or
defective cutting blade.
Switch off engine immediately.
Have defective parts replaced.
Cutting mechanism does
not discharge grass or cuts
unevenly.
Engine speed too low. Increase throttle.
Travelling speed too high. Set to a lower travelling speed.
Cutting blade is blunt. Arrange for service agent to sharpen
or replace blade.
Engine is running, cutter
deck is not mowing.
V-belt torn. Have the V-belt replaced in a repair shop.
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für MTD Zero Turn Serie Z-Force SZ wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von MTD Zero Turn Serie Z-Force SZ

MTD Zero Turn Serie Z-Force SZ Bedienungsanleitung - Deutsch - 19 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info