467082
40
Zoom out
Zoom in
Vorherige Seite
1/48
Nächste Seite
40
A. Move the collective pitch stick to the minimum position:
Set the nominal rotational speed by adjusting the centre point of servo 5
(throttle).
B. Set the collective pitch stick to the hover setting (centre):
The model should now hover at an unchanged rotational speed. Adjust the
throttle servo until this is the case. If the model hovers above or below the cen-
tre point of the collective pitch stick, the setting of servo 4 (collective pitch)
should be adjusted until you can return the stick to centre.
C. Set the collective pitch stick to maximum collective pitch:
The model should now climb at an unchanged rotational speed, with the car-
burettor fully open, and the motor producing maximum power. If the rotational
speed falls off, the maximum collective pitch value is too high, and you need to
reduce the value for servo 4 (collective pitch).
Static tail rotor compensation
Static tail rotor compensation also needs to be fine-tuned, but this cannot be done
until the throttle and collective pitch curves are correctly set up, and system rota-
tional speed stays constant over the full range of collective pitch. Set the helicopter
in a climb and then allow it to descend again. The model should not yaw (swing
away from its heading) at any time (see 8.6.3).
9. Auxiliary functions
9.1. Stopwatch / MOTOR OFF switch
The COCKPIT
MM
features a stopwatch with variable alarm function and a MOTOR OFF
function. Both functions are controlled by one single 3-position switch.
Centre setting: stopwatch stopped, motor running
End-point 1: stopwatch running, motor running
End-point 2: motor cuts (EMERGENCY OFF), stopwatch stopped
Suitable switches are:
# 7 5740: 3- position, latching in all three positions (On/Off/On)
or # 7 5707: 3- position, latching at one end-point,
momentary at the other (On/Off/Momentary)
!!
The switch must be connected to socket S1 in the transmitter (see 4.1.6.)!
Stopwatch
The stopwatch is accurate to 1/10 second and can be read off in the first line of
operating screens INFO 2 and INFO 3. The stopwatch can be reset in operating
screen INFO 2 or INFO 3 by pressing the 3D digi-adjustor.
If you set an alarm time, the stopwatch counts upwards to this time. 10 seconds
before reaching the alarm the piezo sounder starts beeping once every second.
After reaching the set alarm time the stopwatch carries on running. A trill an-
nounces the set alarm.
40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

multiplex-cockpit-mm

Suche zurücksetzen

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Multiplex Cockpit MM wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Multiplex Cockpit MM

Multiplex Cockpit MM Bedienungsanleitung - Deutsch - 48 seiten

Multiplex Cockpit MM Bedienungsanleitung - Französisch - 48 seiten

Multiplex Cockpit MM Bedienungsanleitung - Italienisch - 48 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info