Bedienungsanleitung MundoClima MUPO-07-C9 (Seite 41 von 116) (Deutsch, Englisch, Französisch, Portugiesisch, Spanisch)

726071

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

o person carrying out work in relation to a refrigeration system which involves exposing

any pipe work shall use any sources of ignition in such a manner that it may lead to the

risk of fire or explosion. All possible ignition sources, including cigarette smoking, should

be kept sufficiently far away from the site of installation, repairing, removing and

disposal, during which refrigerant can possibly be released to the surrounding space.

Prior to work taking place, the area around the equipment is to be surveyed to make

sure that there are no flammable hazards or ignition risks.

‘No Smoking’ signs shall be displayed.

5.Ventilated Area(open the door and window):

Ensure that the area is in the open or that it is adequately ventilated before breaking

into the system or conducting any hot work. A degree of ventilation shall continue during

the period that the work is carried out. The ventilation should safely disperse any

released refrigerant and preferably expel it externally into the atmosphere.

6.Checks to the refrigeration equipment:

Where electrical components are being changed, they shall be fit for the purpose and

to the correct specification. At all times the manufacturer’s maintenance and service

guidelines shall be followed. If in doubt, consult the manufacturer’s technical

department for assistance. The following checks shall be applied to installations using

flammable refrigerants:

● The charge size is in accordance with the room size within which the refrigerant

containing parts are installed.

● The ventilation machinery and outlets are operating adequately and are not obstructed.

● If an indirect refrigerating circuit is being used, the secondary circuit shall be checked

for the presence of refrigerant.

● Refrigeration pipe or components are installed in a position where they are unlikely to

be exposed to any substance which may corrode refrigerant containing components,

unless the components are constructed of materials which are inherently resistant to

being corroded or are suitably protected against being so corroded.

7.Checks to electrical devices:

Repair and maintenance to electrical components shall include initial safety checks and

component inspection procedures. If a fault exists that could compromise safety, then

no electrical supply shall be connected to the circuit until it is satisfactorily dealt with. If

the fault cannot be corrected immediately but it is necessary to continue operation, an

adequate temporary solution shall be used. This shall be reported to the owner of the

equipment so all parties are advised.

Initial safety checks shall include:

● That capacitors are discharged: this shall be done in a safe manner to avoid possibility

of sparking.

● That no live electrical components and wiring are exposed while charging, recovering

or purging the system.

● Keep continuity of earthing.

4.No ignition sources:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

MundoClima MUPO-07-C9 Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info