1. TFT -LCD display
2. CHG: Charging indicator (RED indicator: under battery charging mode, Light turns off:
battery is fully charged)
3. : Power indicator (red: standby mode; green: power on)
4. Speakers
5. /MODE: T o turn on/off the unit (standby); T o select different operation mode: DTV/A V .
6.
EXIT
: (Return Key): T o exit current menu and return to previous Menu.
7.
MENU
: T o access the main menu.
8. Antenna jack
9.
CH+/-
, ▲ /▼ : Channel selection; upward / downward keys.
10.
VOL+/-
, ◄ / ► : V olume adjustment; leftward / rightward keys.
1 1.
OK
: T o conrm the selection.
12. Remote sensor
13.
ON/OFF
power switch
14.
DC INPUT (12V)
jack
15. Flute for installing the supporting stand.
16. USB port
17.
A V output
jack
18.
A V input
jack
19. Headphones jack
M-1 15 TV
GB - 1
Please read the instruction carefully
before operating the unit.
LOCA TION OF CONTROLS
Main Unit
GB - 2 GB - 3
GB - 6 GB - 7 GB - 8 GB - 5
Portable TV
User Manual
The supplied AC adaptor is suitable for use on AC mains supplies of 100-240V AC
and should only be connected to a mains supply within these parameters.
Cautions:
* The AC adaptor included with this unit is f or its use only . Do not use it with other
equipment.
* Turn of f the unit before unplugging the AC adaptor from the unit so as to avoid the
unit being damaged.
* When the unit is not going to be used for long time, disconnect the AC adaptor from
the AC outlet.
* Be sure to use it near the wall outlet and easily accessible. If a malfunction occurs,
disconnect the plug from the wall outlet at once.
* AC adaptor is used as the disconnect device. It shall remain readily operable and
should not be obstructed during intended use. T o be completely disconnected the
apparatus from supply mains, the AC adaptor of the apparatus shall be disconnected
from the mains socket outlet completely .
* Never use an AC adaptor that is damaged, route power lead in a safe manner and
make sure it is not subjected to trapping or pinching. If the power lead is damaged
refer to a qualied service agent.
Using the Built- in battery
T o recharge the battery (built-in 3.7V/2500mAh Li-battery)
- The unit has a built-in rechargeable battery (lithium-polymer).
- Charge the built-in battery before using it for the rst time. The normal charging time
is at least 4-6 hours.
- RED power indicator: under battery charging mode; Light turns of f-battery is fully
charged.
- Cannot be charged by car power adaptor .
W arnings:
* T o charge the battery , just connect the AC adaptor .
* Recharge the built-in battery when you are ready to use it again.
* While using the built-in battery , the environmental temperature should be 5°C (41°F)
to 35°C (95°F).
* T o get the longest service life of the built-in battery , charge at indoor-temperature.
* The built-in battery in this device may present a risk of fire or chemical burn if
mistreated. Do not disassemble, heat above 100°C (212°F), or incinerate.
* The unit should not be exposed to excessive heat such as sunshine, re or the like.
* When discarding the unit, environmental problems must be considered and local
rules or laws governing the disposal of such products must be strictly followed.
GB - 9
GB - 4
Front View
Back View
ACCESSORIES
Remote control x1
AC adapter x1
Car plug x1
A V cable x1
DVB-T antenna x1
75 ohm transferring antenna cable x1
Supporting stand with rubber pad x1
Earphones x1
Stand Assemble Instruction Manual
POWER SUPPL Y
Using the AC adaptor
Back view
Using car plug
Back view
CONNECTIONS
Disconnect all devices from the main supply before connecting.
1. Connecting external antenna
* Connect with DVB-T antenna (for outdoor reception)
* Connect with 75 ohm transferring antenna cable (for indoor cable TV)
Another end of this cable will be connected to public antenna for TV .
2. Connecting the A/V cable
Connect the A/V cable to the
A V OUT
jack or
A V IN
jack. The yellow , white and red
end of this cable will be connected to video/audio accordingly . Press
MODE
button to
select “A V”.
Note: A V OUT is only available in HDTV or
USB
mode.
If you connect the DVB-T antenna, please set the antenna setting “ON”;
while connect 75 ohm transferring antenna, set the antenna setting “OFF”.
(Please refer to the
“DVB-T Installation Guide”.
)
Note:
In a concern of saving energy , when playback has reached to the end and no control
is operated on the device for a period of 3 hours, the unit will automatically switch to
Standby mode. (A V mode)
AV transfer-connected cable (supplied)
BASIC OPERA TION
English
INST ALLA TION
W ARNING: Disconnect this car power adaptor when not in use. Not for use in
24V vehicles.
Cautions
* Use only the included 1 2 V car power adaptor . Use of any other 1 2 V car power
adaptor could damage the unit.
* The 12V car power adaptor included is for use with this unit only . Do not use it with
any other equipment.
* In the interest of trafc safety , drivers should not operate the unit or view videos while
driving.
* Make sure the unit is fastened correctly to prevent from falling in the vehicle in the
event of an accident.
* When the inside of the cigarette lighter socket is dirty with ashes or dust, the plug
section may become hot due to poor contact. Be sure to clean the cigarette lighter
socket before use.
* After use, disconnect the car power adaptor from both the unit and cigarette lighter
socket.
1. Connect the AC adapter to wall outlet and slide the ON/OFF power switch to ON
position, power indicator will turn RED to GREEN. (Press and hold / MODE button
for 3 seconds to switch the unit to standby mode, the LCD display lights off and power
indicator turns RED, press / MODE again to power on the unit)
2. Press / MODE button repeatedly to select different source mode: HDTV/ A V .
3. In HDTV mode, press CH+ /▲ , CH- /▼ to change the TV channel.
4. Press VOL+ /►, VOL-/◄ button to adjust the volume level.
5. Press MUTE on remote control to cut off the sound temporarily , press this button
again to resume the sound.
6. Slide the ON/OFF switch to turn off the unit; disconnect the AC adapter from wall outlet,
the unit will be completely shut off.
2. To the cigarette
lighter socket
1. CAR PLUG - 12V jack
Car adaptor
DVB-T Antenna
(supplied)
Step One: Loose the Stand Head’s locker to move the Unit Lock easier as Pict.-1/-2
Step T wo: Make an enough place to put the stand head into unit as Pict.-3
Step Three: Lock the stand into the unit as Pict.-4/-5/-6/-7
Step Four: Completed as Pict.-8
1 - . t c i P 2 - . t c i P
3 - . t c i P 4 - . t c i P
Pict.-5 Pict.-6
8 - . t c i P 7 - . t c i P
H1.
POWER
Standby button
H2 . Color buttons (
red, green, yellow , blue
): T o
activates the function according to different color
shows on the display
H3.
0…9
: Number entry
H4. / : T o start reverse or forward accelerated
playback.
H 5 . ▲/▼/◄ / ►: Upward/ downward/ leftward /
rightward keys
H6.
OK
: T o conrm the selection
H7. ►: MP3/ images broadcast
H8.
VOL+/-
: V olume adjustment
H9.
EXIT
: T o exit current menu and return to
previous menu
H10.
P .ADJ/ MENU
: Picture adjustment (for HDTV
mode); T o access the main menu
H1 1.
FAV
: T o show your favorite channel (for HDTV
mode)
H12.
TV/RADIO
: T o switch between TV and radio
channels (for HDTV mode)
H13.
AUDIO
: T o select dif ferent sound mode (for
HDTV mode)
H14.
EPG
(Electronic program guide): T o show the
preview of the program picture (for HDTV mode)
H15.
MUTE
: T o cut of f or restore the sound
H16. : T o return to last channel
H17.
USB
: Display USB PVR program list
H18. / : next or previous
H19.
CH+/-
: Channel selection
H20. : T o PLA Y and P AUSE playback
H21.
MODE
: T o select different operation mode
(HDTV/A V)
H22.
SUBTITLE
: T o turn on / of f the subtitle (for HDTV mode)
H23.
INFO
: T o show the information of current program
H24. : Record button
H25. : stop button
H26.
TEXT
: T o turn on / of f the teletext information (for HDTV mode)
Installing Battery
Insert 2 “AAA/ UM4” batteries to the remote control prior to use. Make sure to match their
polarities (+/-) to the markings inside the compartment.
Remote control
Before throwing any batteries away , consult your distributor who may be
able to take them back for specic recycling.
NOTES:
- Never recharge the batteries, apply heat to them or take them apart.
- If the remote control is not going to be used for a long time, remove the battery to avoid
damage caused by battery leakage corrosion.
- Attention should be drawn to the environmental aspects of battery disposal.
- Do not throw batteries in re!
- Battery shall not be exposed to excessive heat such as sunshine, re or the like.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type.
USING HEADPHONES / EARPHONES
Maximum output voltage ≤ 150mV
Wide Band Characteristic V oltage ≥ 75mV
HEADPHONE VOLUME W ARNING
Connect earphones with the volume set low and increase it if required. Prolonged listening
through some earphones at high volume settings can result in hearing damage. When
headphones / earphones are connected, no sound will be emitted from the unit’s speaker .
Caution: A void listening to sound at levels which may be harmful to your ears.
T o prevent possible hearing damage, do not listen at high volume
levels for long periods.
PTM-3036A IB MUSE 001 REV0 - GB.indd 1 2016/12/1 17:36:51