Bedienungsanleitung Mustang GOURMET 3 plus 1 (Seite 12 von 40) (Englisch, Schwedisch, Finnisch)

798956

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

EN.

regulator, burner, and burner ports. Spiders and

insects can nest within and clog the burner and its

inlet. A clogged burner can lead to a re beneath

the barbecue.

Clean burner holes with a heavy-duty pipe cleaner.

Fit the hose to the appliance using a spanner to

tighten it onto the connection thread. If the hose is

replaced, it must be secured to the barbecue and

regulator connections with hose clips. Disconnect

the regulator from the cylinder according to the

directions when the barbecue is not in use.

The Barbecue must be operated in a well-ventilated

area. Do not obstruct the ow of combustion air to

the burner when the barbecue is in use. ONLY USE

THIS BARBECUE OUTDOORS.

BEFORE USE, CHECK FOR LEAKS IN THE HOSE AND/

OR CONNECTION THREADS.

Never check for leaks with a naked ame, always

use a soapy water solution.

CHECKING FOR LEAKS

Make 2-3 uid ounces (6-9 dl) of leak detecting

solution by mixing one part dishwashing liquid with

3 parts water.

Ensure that the control valve is “OFF”.

Connect the regulator to the LP gas cylinder and

ON/OFF valve to the burner. Ensure that the con-

nections are secure and then turn the gas ON.

Brush the soapy solution onto the hose and all

joints. If bubbles appear you have a leak, which

must be rectied before use.

Retest after xing the fault.

Turn the gas OFF at the LP gas cylinder after test-

ing.

If leakage is detected and cannot be rectied, con-

sult your gas dealer in order to x the leak.

LIGHTING YOUR BARBECUE

Before cooking for the rst time, operate the barbe-

cue for about 15 minutes with the lid closed and the

gas turned on to maximum. This will “heat clean” the

internal parts.

Clean your barbecue after each use. DO NOT use

abrasive or ammable cleaners, as it will damage

the parts of the product and may start a re. Clean

the barbecue with warm soapy water.

WARNING: Accessible parts may be very hot. Keep

children away from the hot barbecue at all times

(even when the appliance is cooling down!). Protec-

tive gloves (e.g. oven gloves) should be used when

handling particularly hot components.

IMPORTANT!

Do not use the rear rotisserie burner when using

the main burner

Main burner ignition instruction

1. Open the lid of the barbecue before igniting the

burners.

2. Turn all of the knobs clockwise to the OFF posi-

tion (•).

3. Connect the pressure regulator to the liquid gas

cylinder. Turn the gas supply of the pressure regula-

tor to the ON position. Use soapy water to check for

any gas leaks between the liquid gas cylinder and

the pressure regulator.

4. Push and hold down the knob, and then turn it

counter-clockwise until you feel a spring resistance.

Keep the knob in this position for 3-5 seconds to

allow the gas to ow. Turn it counter-clockwise to

“MAX ” position. Check if the burner has ignited. If

the burner has not ignited, repeat the process.

5. If the burner still won’t ignite, turn the knob to

the OFF position (•), wait about 5 minutes, and

repeat step 4.

6. Move the knob between the Min. and Max. posi-

tions to adjust the temperature.

7. Ignite the other burners by pushing and holding

each corresponding knob and turning the knobs

counter-clockwise to the Max position. The ignition

unit between the burners will ignite the burners.

Light the burners in order.

8. If the burner won’t ignite, use a match to ignite

the barbecue from the ignition hole in the side of

the barbecue.

9. Turn the barbecue o by turning the valve of the

liquid gas cylinder or the valve of the pressure reg-

ulator to the OFF position, and then turn the knobs

of the barbecue to the OFF (•) position.

Warning! If the burner won’t ignite, turn the knob

(clockwise) to the OFF position and close the valve

of the liquid gas cylinder. Wait 5 minutes before

trying to ignite the barbecue again by following the

instructions.

Side burner ignition instruction

1. Open the lid of the side burner (if delivered) be-

fore igniting.

2. Push and hold down the side burner knob, and

then turn it counter-clockwise until you feel a

spring resistance. Hold the knob in this position for

3-5 seconds to allow the gas to ow, and then turn

it counter-clockwise to “MAX ” position. Check if the

burner has ignited. If the burner has not ignited,

repeat the process.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mustang GOURMET 3 plus 1 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info