667812
8
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
9 RS 232
NAD is a certied partner of AMX and Crestron and fully supports
these external devices. Check out the NAD website for information
about AMX and Crestron compatibility with NAD. See your NAD audio
specialist for more information.
Connect this interface using RS-232 serial cable (not supplied) to
any Windows compatible PC to allow remote control of the C 510
via compatible external controllers.
Refer to the NAD website for information about RS232 Protocol
documents and PC interface program.
10 +12V TRIGGER IN
With this input triggered by a 12V DC supply, the C 510 can be switched
ON remotely from standby mode by compatible devices such as
ampliers, preampliers, receivers, etc. If the 12V DC supply is cut o,
the C 510 will return to standby mode.
Connect this +12V Trigger input to the remote devices
corresponding +12V DC output jack using a mono cable with
3.5mm male plug. The controlling device must be equipped with a
+12V trigger output to use this feature.
WARNING
The front panel Standby button is disabled as long as the male plug
of the mono cable (with or without +12V DC) is connected to C 510’s
+12V TRIGGER IN. Unplug the mono cable for the C 510 to be normally
switched ON (or back to standby mode) using the front panel STANDBY
button.
11 IR IN
This input is connected to the output of an IR (infrared) repeater
(Xantech or similar) or the IR output of another component to allow
control of the C 510 from a remote location.
12 POWER
Supply the AC mains power to the C 510.
When the POWER switch is set to ON position, the C 510 goes to
standby mode as shown by the amber status condition of the
Standby LED. Press the front panel Standby button or remote
control’s [ON] button to switch ON the C 510 from standby mode.
If you intend not to use the C 510 for long periods of time (such as
when on vacation), switch o the POWER switch.
With POWER switched o, neither the front panel Standby button
nor remote control’s [ON] button can activate the C 510.
13 AC MAINS INPUT
The C 510 comes supplied with a separate detachable mains power
cord.
Before connecting the plug to the mains powers source, connect
rmly rst the other end to C 510’s AC Mains input socket.
Always disconnect the mains power plug from the mains power
source rst, before disconnecting the other end from the C 510’s AC
Mains input socket.
14 FUSE HOLDER
Only qualied NAD service technicians can have access to this fuse
holder. Opening this fuse holder may cause damage thus voiding
the warranty of your C 510.
IDENTIFICATION OF CONTROLS
REAR PANEL
8
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSK A РУССКИЙ
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für NAD C 510 Direct Digital DAC wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von NAD C 510 Direct Digital DAC

NAD C 510 Direct Digital DAC Bedienungsanleitung - Deutsch - 16 seiten

NAD C 510 Direct Digital DAC Bedienungsanleitung - Holländisch - 16 seiten

NAD C 510 Direct Digital DAC Bedienungsanleitung - Französisch - 16 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info