Bedienungsanleitung NAD D7050 (Seite 10 von 16) (Englisch)

562258

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

CONNECT AIRPLAY

AirPlay lets you stream music from your AirPlay-enabled device to the

D7050. The AirPlay-enabled device and the D7050 must be in the same

network to send and receive streaming audio with AirPlay. This connection

could be wired, using Ethernet cable, or wireless.

SETTING UP NETWORK CONNECTION

The D7050 can be connected to a network using any of the following

methods

A Wired connection

B Wireless connection

C Share Wi-Fi setting

Start playback of your device after successful network connection using any

of the above methods.

WIRED CONNECTION

Network connection using Ethernet broadband connection. Set up a Wired

Ethernet broadband router with broadband internet connection. Your

router or home network should have a built-in DHCP server to consummate

the connection.

1 Using a standard straight-through Ethernet cable (not supplied),

connect one end of the Ethernet cable to the LAN port of your wired

Ethernet broadband router and the other end to D7050’s LAN port.

2 Connection is established when a solid signal strength bar indicator

appears in the upper right corner of the D7050 display.

It is advisable that wired connection is utilized when possible. Wired

connection is less likely to have “drop-out” or range problem and not

vulnerable to interference or eavesdropping.

WIRELESS CONNECTION

Wireless (WiFi) broadband router with broadband internet connection

is required for wireless connection to be established. D7050 can be

connected wirelessly via two methods

A WPS key pairing

B Access point mode

WPS KEY PAIRING

1 Short press the WPS button located at the rear panel of D7050. Press

also the corresponding WPS button in your router. A ashing signal

strength bar indicator appears in the upper right corner of the

D7050 display.

2 The D7050 will attempt to detect the WPS signal from the router and

establish a wireless connection.

3 Wireless connection is established when the ashing signal bar

indicator turns to solid bar.

ACCESS POINT MODE

The D7050 can act as an Access Point (AP) enabling it to connect to a wired

network wirelessly.

1 Press and hold WPS button located at the rear panel of D7050 for

about 3 seconds and then release it. A ashing signal strength bar

indicator appears in the upper right corner of the D7050 display.

2 Using your iOS device (iPad is used here for reference), select among

the list of available network connections the unique network ID (D7050

00EBC8 in this example) of your D7050.

3 Launch Safari and enter http://192.168.1.1. The NAD AirPlay Setup

menu window will appear. While at Network Conguration section,

select Select Option at Service Set ID (SSID).

OTHER FEATURES

ENGLISH PORTUGUÊSFRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

NAD D7050 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von NAD D7050

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info