667813
6
Zoom out
Zoom in
Vorherige Seite
1/22
Nächste Seite
1 o (STANDBY)
Press o (Standby) button for the M12 to be switched ON from
standby mode. The Power indicator will turn from amber to bright/
white color.
Pressing o (Standby) button again switches back M12 to standby
mode. The Power indicator will illuminate to amber color at standby
mode.
The o (Standby) button cannot activate the M12 with the rear
panel POWER switched o.
IMPORTANT NOTES
Refer also to +12V TRIGGER (IN/OUT) in IDENTIFICATION OF CONTROLS
– REAR PANEL.
For the o (Standby) button to activate, two conditions must be
completed.
a. Plug-in the supplied mains power cord to a mains power source.
Connect corresponding end of the mains power cord to the AC
mains input of M12 and the plug connected to a mains power
source.
b. The rear panel POWER switch must be set to ON position.
2 POWER INDICATOR
This indicator will light up amber when the M12 is at standby mode.
When the M12 is powered up from standby mode, this indicator
will turn from amber to bright/white color.
3 REMOTE SENSOR
Point the HTRM 2 remote control at the remote sensor and press
the buttons.
Do not expose the remote sensor of the M12 to a strong light
source such as direct sunlight or illumination. If you do so, you may
not be able to operate the M12 with the remote control.
Distance: About 23ft (7m) from the front of the remote sensor.
Angle: About 30° in each direction of the front of the remote sensor.
4 DISPLAY (TOUCH PANEL DISPLAY)
Show visual and menu information according to the display
settings selected.
The following display options are accessible via the touch panel
display - Main, Media, Mode, EQ and Setup.
Use your nger to press and select any of these display options to
show their corresponding menu options or settings.
5 VOLUME
The VOLUME control adjusts the overall loudness of the signal being
fed to the loudspeakers. Volume control is characterized by perfect
signal tracking and channel balance. It gives a highly linear and low
noise operation.
Turn clockwise to increase the volume level; counter clockwise to
lower it.
The default volume level is -20dB.
6 DIGITAL USB FRONT
Connect a USB mass storage device to this input. Typical USB
mass storage devices compatible with M12 include portable ash
memory devices and external hard drives (FAT32 formatted).
Refer also to the item about LISTENING TO USB DEVICE at the
OTHER FEATURES section of the OPERATION page.
IDENTIFICATION OF CONTROLS
FRONT PANEL
© NAD M12
M12
DIGITAL PREAMP DAC
4 652 3
1
6
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für NAD M12 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von NAD M12

NAD M12 Bedienungsanleitung - Deutsch - 22 seiten

NAD M12 Bedienungsanleitung - Holländisch - 22 seiten

NAD M12 Bedienungsanleitung - Französisch - 22 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info