Bedienungsanleitung NAD M3e (Seite 13 von 20) (Englisch)

602914

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

ENGLISH

FRANÇAISDEUTSCHNEDERLANDSESPAÑOL

ITALIANO

PORTUGUÊS

SVENSKA

8. REC/Z2: This output is a steady state line-level output. Connect this output to recording

equipment such as an audio tape deck or an A/D Converter recorder.

One may also connect this output to an auxiliary piece of audio equipment such as an

integrated amplifier for multi-zone operation. In such a case, use this output in conjunction

with the ZR3 remote control and IR IN. (refer to the IR IN section below).

9. SPEAKERS A: Connect speakers with impedance of 4 Ohms or greater. Connect the right

speaker to the terminals market 'R +' and 'R-' ensuring that the 'R+' is connected to the

'+' terminal on your loudspeaker and the 'R-' is connected to the loudspeaker's '-' terminal.

Connect the terminals marked 'L+' and 'L-' to the left speaker in the same way. When

using both SPEAKERS A and SPEAKERS B connect speakers of impedance 8 Ohms or

greater.

10. SPEAKERS B: Connect speakers with impedance of 4 Ohms or greater. Connect the right

speaker to the terminals market 'R +' and 'R-' ensuring that the 'R+' is connected to the

'+' terminal on your loudspeaker and the 'R-' is connected to the loudspeaker's '-' terminal.

Connect the terminals marked 'L+' and 'L-' to the left speaker in the same way. When

using both SPEAKERS A and SPEAKERS B connect speakers of impedance 8 Ohms or

greater.

NOTES: When connecting both SPEAKERS A and B, connect speakers with impedance no

less than 8 Ohms.

Always use heavy duty (16 gauge/2 square mm or thicker) stranded wire to connect

loudspeakers to your M3.

The high current binding post terminals can be used as a screw terminal for cables

terminating in spade or pin connectors or for cables with bare wire ends.

SPADE CONNECTORS (Figure 3)

These should be slotted under the terminal's screw bushing, which is then fully tightened.

Ensure the connector is tightly secured and there is no danger of bare metal from spade

connectors touching the back panel or another connector as this may cause damage.

BARE WIRES AND PIN CONNECTORS (Figure 3)

Bare wires and pin connectors should be inserted into the hole in the shaft of the terminal.

Unscrew the speaker terminal's plastic bushing until the hole in the screw shaft is revealed.

Insert the pin or bare cable end into the hole and secure the cable by tightening down the

terminal's bushing.

Avoid any danger of bare metal from the speaker cables touching the back panel or

another connector. Ensure that there is only 1/2" (1cm) of bare cable or pin and no loose

strands of speakers wire.

11. IR IN & IR OUT 2: Use these 3.5 mm mini-jack connectors to pass commands from other

units with similar IR (infrared) connectors. Daisy-chain other hi-fi system's IR outputs to the

M3's IR IN and then M3's IR OUT 2 to other hi-fi systems' IR inputs so that control of a

whole system via a single remote control facility is from one unit with a single IR

connection.

NOTES:

IR OUTPUT 1 is hard wired to the M3’s front panel IR sensor. Only Daisy-chain the IR IN with

IR OUT 2 when connecting the M3 as part of a series IR configuration.

Your custom installer or dealer can assist you in the proper setup and configuration of

infrared multi-room hi-fi systems.

About the M3 Dual Mono Integrated Amplifier

Setup

M3 10262005.qxd 1/3/2006 2:49 PM Page 13

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

NAD M3e Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von NAD M3e

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info