Bedienungsanleitung NAD PP3i (Seite 2 von 2) (Englisch)

602916

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

TROUBLESHOOTING

Always turn down the volume to a low level or turn o all equipment before checking.

PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION

No sound. • (LED is not illuminated) Power Supply not connected

to either NAD PP 3i or mains socket.

• Plug in dedicated Power Supply.

• (LED is illuminated) Wrong input on amplier/receiver

selected.

• Select input to which NAD PP 3i is connected.

• Check to see if the MM/MC selector switch is set

correctly for your type of turntable cartridge (make

sure to turn o all equipment beforehand).

• Plugs from turntable and/or lead from NAD PP 3i to

amplier/receiver sockets not property tted.

• Check all connections (make sure to turn o all

equipment beforehand).

Sound in one channel only. • Plugs from turntable and/or lead from NAD PP 3i to

amplier/receiver sockets not property tted.

• Check all connections (make sure to turn o all

equipment beforehand).

Hum or Buzz noise. • No connection from turntable to ground. • Connect the turntable’s earth (GND) lead directly to

a ground connection or to NAD PP 3i’s thumb screw

terminal “GND” which provides the grounding.

• Earth loop present. • If connected, disconnect turntable’s earth lead from

amplier/receiver.

• Interference from nearby equipment • Move NAD PP 3i and cables further away from other

equipment.

SPECIFICATIONS

MM SPECIFICATIONS

Input impedance (R and C) 47 kohms + 200 pF

Gain at 1 kHz 35 dB

Input sensitivity for 300 mV output 5 mV

Signal-to-noise ratio 76 dB (A-weighted, with cartridge connected)

65 dB (Unweighted, with cartridge connected)

Input overload (20Hz/1kHz/20kHz) 10/100/900 mV

Total Harmonic Distortion <0.03% (20 Hz – 20 kHz at 3V output)

RIAA response accuracy ±0.3 dB

Infrasonic lter -14 dB (5 Hz)

-3 dB (10 Hz)

Digital output (USB) 16 bit linear PCM

Sampling frequency 48 kHz

Dynamic range 89 dB

GENERAL SPECIFICATIONS

AC supply External 24V DC (analogue circuitry)

+5 V from USB (digital circuitry)

Unit dimensions (W x H x D) 135 x 43 x 72 mm

MC SPECIFICATIONS

Input impedance (R and C) 100 ohms + 180 pF

Gain at 1 kHz 58 dB

Input sensitivity for 300 mV output 0.38 mV

Signal-to-noise ratio 78 dB (A-weighted, with cartridge connected)

70 dB (Unweighted, with cartridge connected)

Input overload (20Hz/1kHz/20kHz) 0.65/6.5/60mV

Total Harmonic Distortion <0.03% (20 Hz – 20 kHz at 3V output)

RIAA response accuracy ±0.3 dB

Infrasonic lter -14 dB (5 Hz)

-3 dB (10 Hz)

Digital output (USB) 16 bit linear PCM

Sampling frequency 48 kHz

Dynamic range 86 dB

Specications are subject to change without notice.

For updated documentation and features, please check out

www.NADelectronics.com for the latest information about PP 3i.

No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.

While every effort has been made to ensure the contents are accurate at the time of publication, features and specifications may be subject to change without prior notice.

PP3I_ENG_OM_V04  05/12

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

NAD PP3i Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von NAD PP3i

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info