Initial Settings
GB
20
Each DVD disc has a variety of audio output options. Set the player’s
Digital Audio Output according to the type of audio system you use.
1 At the SETUP screen, press to select Digital Audio Output
and press
2Press to select the desired output and press
SELECT/ENTER
DOLBY DIGITAL/PCM : Select DOLBY DIGITAL/PCM if an active digital
output is supplied to a Dolby Digital decoder, (or an amplifier or other
equipment with Dolby Digital decoder). In this mode, the T531 will
automatically switch between Dolby Digital and Stereo PCM depending
on the program encoded on the disc, with Dolby Digital given priority.
DTS is not possible with this setting.
Stream/PCM : Select Stream/PCM if an active digital output is supplied
to an amplifier or other
equipment with DTS decoder, Dolby Digital decoder and MPEG decoder.
PCM : Select PCM if an active digital output is supplied to an amplifier
or other equipment with linear PCM only (or MD recorder or DAT deck).
5.1 Surround Sound modes are not possible with this setting.
NOTES
• When you are not using the player’s digital audio output, don’t select
any of the options.
• If an active digital audio output signal is supplied to a receiver or
other equipment without a corresponding digital decoding capability,
a very loud noise may be produced which could permanently
damage the speakers.
• The DTS DVD disc sound is played back only when the DVD player is
connected to a receiver with a DTS decoder.
SELECTING DIGITAL AUDIO OUTPUT
1,2
96 kHz Linear PCM
DVD
PCM PCM PCM
DTS DVD DTS bit Stream Not Output Not Output
Dolby Digital DVD Dolby Digital bit
Stream
Dolby Digital bit
Stream
PCM
MPEG DVD MPEG bit Stream PCM PCM
Audio CD PCM PCM PCM
DTS Audio CD DTS bit Stream DTS bit Stream DTS bit Stream
Playback Disc
OUTPUT
Stream/PCM Dolby Digital/PCM PCM only
