Bedienungsanleitung NAD T 757 (Seite 7 von 44) (Englisch)

493495

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

6 VACUUM FLUORESCENT DISPLAY (VFD)

• Displays visual information about the current settings like the active

Source, volume level, listening mode, audio format, applicable

RDS/XM/DAB as well as iPod-related display information and other

related indicators.

• Refer also to the item about DISPLAY SETUP under the USING THE

T 757 - SETUP MENU segment of the OPERATION section.

7 REMOTE SENSOR

• Point the AVR 4 remote control at the remote sensor and press the

buttons.

• Do not expose the remote sensor of the T 757 to a strong light

source such as direct sunlight or illumination. If you do so, you may

not be able to operate the T 757 with the remote control.

Distance: About 23ft (7m) from the front of the remote sensor.

Angle: About 30° in each direction of the front of the remote sensor.

8 3 SOURCE 4

• Toggle through the input selections - Source 1, Source 2, Source 3,

Source 4, iPod, Source 7, Front Input, Media Player and Tuner (AM/

FM/DAB/XM as applicable). More Sources can be directly recalled

upon enabling them at the Setup Menu.

• Refer also to the item about SOURCE SETUP under the USING THE

T 757 - SETUP MENU segment of the OPERATION section.

9 VOLUME

• The VOLUME control adjusts the overall loudness of the signal being

fed to the loudspeakers or headphones.

• Turn clockwise to increase the volume level; counter clockwise to

lower it.

10 PHONES

• Accepts stereo headphone using a standard 1/4-inch stereo phone

plug (use a suitable adaptor for headphones equipped with a

smaller plug).

• Plugging in headphones automatically mutes output from the

speakers.

• For headphone listening, the Front speakers must be set to “Large” at

the “Speaker Conguration” of the Speaker Setup item at the Setup

Menu; otherwise headphone bass response will be restricted.

• Plugging in headphones will automatically switch the T 757 to

Stereo, Stereo Downmix or Analog Bypass modes.

11 FRONT INPUT PORTS

• Use these convenience jacks for occasional sources such as a

camcorder, video game console, any analog audio or optical digital

audio sources and composite video sources.

• If your source has two output jacks indicative of stereo output,

insert both jacks into the T 757’s corresponding Front “L” (item A) and

“R (MONO)” input to achieve stereo output as well.

• On the other hand, if your source has a single audio out jack only or

is marked “Mono output”, plug this into the T 757’s Front “R (MONO)”

input (item B).

• Connect composite video output source to the front composite

video input (item C).

• Use the front optical audio input (item D) for optical digital audio

sources.

12 FRONT MP/MIC INPUT

• Connect your Media Player’s standard stereo phone jack to this

input.

• This is also the same input where the supplied Audyssey

microphone is connected for Audyssey Setup calibration.

• Refer also to the item about AUDYSSEY SETUP under the USING THE

T 757 - SETUP MENU segment of the OPERATION section.

IDENTIFICATION OF CONTROLS

FRONT PANEL

ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

NAD T 757 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von NAD T 757

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info