Bedienungsanleitung Naim UnitiServe (Seite 7 von 29) (Englisch)

707496

Zoom out

Zoom in

Vorherige Seite

1/29

Nächste Seite

Installation - Getting Started

2.5 External Screen Setup

If an external display is used, the UnitiServe-SSD external

display setup may need to be modified. Navigate, via the

System menu, to the System Settings menu. Select and

save the desired External Display Theme, External Display

Aspect Ratio, External Display Mode and TV System. Initially

disable the Screen Saver (found on System Setup page 1).

Note: The External Display Mode setting configures the

external display for use with either an external touch

screen or a remote handset. In touch screen mode, four

shortcut buttons are displayed on the right of the screen

that correspond to the home, browse, find and back keys

on the remote handset. The on screen shortcut buttons

can only be accessed from the touch screen so are not

shown in remote control mode.

Note: Once you have become used to the interface and

are familiar with its functions the screen saver can be

re-enabled.

2.6 First Use

Before attempting to rip a CD you must ensure that the

necessary Network Attached Storage (NAS) disk drive is

appropriately configured, connected to the network, and

switched on. Section 7 of this manual describes the use

and configuration of external storage.

To rip a CD, insert the CD into the transport slot. The ripping

process will begin automatically. When CD ripping is

complete UnitiServe-SSD will eject the CD automatically.

See Section 6 for further information on ripping CDs.

Only CDs owned personally should be ripped. Ripping a

borrowed CD may violate copyright law.

Note: Although UnitiServe-SSD contains a small internal

music database, to be able to identify a CD and

download its associated data during the ripping process, it

must be connected to a working internet connection.

2.7 Software Upgrade

Software upgrade CDs will occasionally be released

for UnitiServe-SSD. New software is installed simply by

inserting the upgrade CD in the transport. The software

upgrade process will commence automatically. As part

of the upgrade process UnitiServe-SSD will eject the CD

and re-boot. The upgrade process is complete once the

interface returns to the Home Menu.

Note: Any specific instructions included with the upgrade

CD should be followed carefully.

Never switch off UnitiServe-SSD from the rear panel power

switch or unplug it from the mains supply while a software

upgrade process is underway.

2.8 Switching Off

Switching off UnitiServe-SSD from its rear panel power

switch is not normally necessary unless it is to be

un-installed. It can be put into shutdown mode by

touching the front panel logo for five seconds. UnitiServe-

SSD may take up to one minute to enter shutdown mode

during which time the logo will flash. Wait until the logo

stops flashing before switching off UnitiServe-SSD from the

rear panel power switch.

Never switch off UnitiServe-SSD from the rear panel power

switch or unplug it from the mains supply unless it is in

shutdown mode.

To switch UnitiServe-SSD back on from shutdown mode, the

power switch must be switched off and on again.

2.9 Data Backup

UnitiServe-SSD does not incorporate an integral backup

disk drive and we strongly advise that you protect your

stored music by implementing a regular backup to a

Network Attached Storage (NAS) hard disk drive.

Implementing regular backups to a network share can be

set up via the UnitiServe-SSD System menu. This is described

in Section 4.8.4.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Naim UnitiServe Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Naim UnitiServe

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info