151589
20
Zoom out
Zoom in
Vorherige Seite
1/23
Nächste Seite
20
Appendix D
PORTABLE MP3 PLAYER
PA11
Size(WxHxD)/Weight
57 x 74 x 22 mm / 50g (without battery)
Memory
Internal Memory
64 MB
Type of removable memory :
1 x Smart Media slot
use 16, 32 and 64MB SMC card
Interface
USB ( using standard USB v1.1 cable )
LCD Display
1 line x icon & 2 lines x 12 characters LCD
Power
1 x AA Alkaline
15 hours for MP3/voice playback
Signal to Noise Ratio
88 dB
Frequency Response
20 Hz ~ 20 KHz
Output
> 5 mW (each output)
Harmonic Distortion Output
0.05 ~ 0.1%
Equalizer
5 presets equalizer
Processor
50 MHz DSP
Audio Codec support
MPEG Audio Layer 3 (MP3)
Firmware
Flash based. User upgradeable.
Voice Recording
IMA-ADPCM encoding.
About 4 hours recording in 64MB Memory
player.
Technical Specification
The player can not power on.
Is Battery polarity (+) / (-) right?
Is Battery capacity enough?
(One 1.5 v AA size Alkaline battery is required.)
Take the battery out and reinstall the battery
to reset the unit.
LCD displays ’Power on / Locked ‘ and power off.
Unlock the
[HOLD]
button and try again
The button is not working.
Is [
HOLD
] button locked? If it is, Unloc
k
the [
HOLD
] button and try again
Take the battery out and reinstall the battery
to reset the unit.
There is no audio produced.
Check the earphone and / or the connectio
n
is working normally.
Check that MP3 files are
NOT
stored i
n
folder(s).
Take the battery out and reinstall the battery
to reset the unit.
Can not download MP3 file(s).
Is USB connection steady? Observe if the
[
USB IDLE
] displays on LCD of the unit.
Check and / or replace the battery.
Is there no free space to download the file?
(Continued on next page)
Troubleshooting
Specifications are subject to change without notice.
Mass and dimensions are approximate.
The unit is controlled by microcircuit an
d
software. So, please
RESET the unit
by taking
out and reinstalling the battery when the uni
t
stops responding. And if the unit still canno
t
work, please
REFRESH
the firmware.
Reset The Unit
The unit will not work if the built-in software
is corrupted. Connect the unit to computer an
d
use
[Firmware Upgrade]
utility to refresh the
software to normal.
Ref. Appendix C : Software Utility
Refresh The Firmware
20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Napa pa 11 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info