Bedienungsanleitung Napoleon BILEX 485 (Seite 6 von 56) (Englisch, Französisch)

637911

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

www.napoleongrills.com

BUILT IN NATURAL GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and

piping should be located as shown in the built-in instrucons. A exible metal connector is included to

simplify the installaon of the unit. Connect this connector to the are ng on the end of the manifold.

Connect the other end of the connector to the gas piping. Ensure that the connector does not pass

through a wall, oor, ceiling or paron, and is protected from damage. Do not use a hose to connect the

unit. It must be connected with rigid pipe, copper tube or an approved exible metal connector which

complies with Z21.4 /CSA 6.10 or ANSI Z21.75/CSA 6.27.

The installaon must comply with CAN B149.1 Natural Gas and Propane Installaon Code in Canada, or

to the Naonal Fuel Gas Code, ANSI Z223.1 in the United States. The gas supply pipe must be suciently

sized to supply the BTU/h specied on the rang plate, based on the length of the piping run. If installing

a side burner, a separate line must be branched o to the side burner unit and enter the side burner

opening at the specied locaon.

WARNING! Built in units are supplied with a drip pan which holds only a minimal amount of

grease. To prevent grease res, the pan must be cleaned aer each use.

WARNING! Access must be provided to the inside of the enclosure to make gas connecons.

DANGER! Read all instrucons carefully before operang the grill. Failure to follow these

instrucons exactly could result in a re causing serious injury or death. The enre installaon must be

leak tested before operang the grill.

Leak Tesng Instrucons

WARNING! A leak test must be performed annually and each me a cylinder is hooked up or if a

part of the gas system is replaced.

WARNING! Never use an open ame to check for gas leaks. Be certain no sparks or open ames

are in the area while you check for leaks. Sparks or open ames will result in a re or explosion,

damage to property, serious bodily injury, or death.

Leak tesng: This must be done before inial use, annually, and whenever any gas components are

replaced or serviced. Do not smoke while performing this test, and remove all sources of ignion. See Leak

Tesng Diagram for areas to check. Turn all burner controls to the o posion. Turn gas supply valve on.

Brush a half-and-half soluon of liquid soap and water onto all joints and connecons of the regulator,

hose, manifolds and valves.

Bubbles will indicate a gas leak. Either ghten the loose joint or have the part replaced with one

recommended by the Napoleon Customer Soluons department and have the grill inspected by a cered

gas installer.

If the leak cannot be stopped, immediately shut o the gas supply, disconnect it, and have the grill

inspected by a cered gas installer or dealer. Do not use the grill unl the leak has been corrected.

STOP

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Napoleon BILEX 485 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Napoleon BILEX 485

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info