Bedienungsanleitung Napoleon Gemini BIPT750RBI (Seite 1 von 24) (Englisch, Französisch)

637949

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

APPLY SERIAL NUMBER LABEL FROM CARTON

Serial No.

XXXXXX000000

MODEL NO.

N415-0175 APR 17.14

BUILT–IN UNIT INSTRUCTION GUIDE

Please use this manual in conjuncon with your main manual to properly assemble your built-in grill. Refer to

the main manual for operang, cleaning, and maintenance instrucons.

WARNING! This grill is designed for  enclosures only, and must be installed and



WARNING!

BUILT IN PROPANE GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping

should be located as shown in the built-in instrucons. A exible metal connector is included to simplify the

installaon of the unit. Connect this exible metal connector to the are ng on the end of the manifold.

Connect the other end of the connector to the gas piping. Ensure that the connector does not pass through a

wall, oor, ceiling or paron, and is protected from damage. Do not use a hose to connect the unit except to

connect the cylinder regulator to the piping system. It must be connected with rigid pipe, copper tube or an

approved exible metal connector which complies with Z21.4 /CSA 6.10.

The installaon must comply with CAN B149.1 Natural Gas and Propane installaon code in Canada, or to the

Naonal Fuel Gas code, ANSI Z223.1 in the United States. The gas supply pipe must be suciently sized to

supply the BTU/h specied on the rang plate, based on the length of the piping run. If installing a side burner,

a separate line must be branched o to the side burner unit and enter the side burner opening at the specied

locaon. If the enclosure is to house a propane cylinder, the tank poron of the enclosure must be venlated

according to local codes, and must not have communicaon with the cavity used to enclose the gas grill. A

propane tank can not be stored below the gas grill.

BUILT IN CYLINDER ENCLOSURES: Built in cylinder enclosures which completely enclose the cylinder must have

both of the following:

1. At least one unobstructed venlaon opening on the exposed exterior side of the enclosure located within

5 in (127 mm) of the top of the enclosure. The opening must have a total free area of more than 20 in

(130

)

for a 20 lb (9.1 kg) cylinder and 30 in

(195 cm

) for a 30 lb (13.6 kg) cylinder.

2. At least one venlaon opening on the exposed, exterior side of the enclosure located 1 in (25.4 mm) or less

from the oor level. The opening must have a total free area of more than 10 in

(65 cm

) for a 20 lb (9.1 kg)

cylinder and 15 in

(100 cm

) for a 30 lb (13.6 kg) cylinder. The upper edge must be no more than 5 in (127

mm) above the oor level.



www.napoleongrills.com

Napoleon Group of Companies







Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Napoleon Gemini BIPT750RBI Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info