Bedienungsanleitung Napoleon PRESTIGE II 750 (Seite 12 von 48) (Englisch, Französisch)

637948

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

www.napoleongrills.com



  

Low heat / Low ame when

valve turned to high.

For propane - improper lighng

procedure.

For natural gas - undersized

supply line.

For both gases - improper

preheang.

Ensure lighng procedure is followed carefully. All

gas grill valves must be in the o posion when the

tank valve is turned on. Turn tank on slowly to allow

pressure to equalize. See lighng instrucons.

Pipe must be sized according to installaon code.

Preheat grill with both main burners on high for 10 to

15 minutes.

Excessive are-ups/uneven

heat.

Sear plates installed incorrectly.

Improper preheang.

Excessive grease and ash build

on sear plates and in drip pan.

Ensure sear plates are installed with the holes towards

the front and the slots on the boom. See assembly

instrucons.

Preheat grill with both main burners on high for 10 to

15 minutes.

Clean sear plates and drip pan regularly. Do not line

pan with aluminum foil. Refer to cleaning instrucons.

Burners burn with yellow

ame, accompanied by the

smell of gas.

Possible spider web or other

debris, or improper air shuer

adjustment.

Thoroughly clean burner by removing. See general

maintenance instrucons. Open air shuer slightly

according to combuson air adjustment instrucons.

(This must be done by a qualied gas installer.)

Flames li away from

burner, accompanied

by the smell of gas, and

possibly dicules in

lighng.

Improper air shuer adjustment. Close air shuer slightly according to combuson air

adjustment instrucons. (This must be done by a

qualied gas installer.)

Burner will not light with

the igniter, but will light

with a match.

Dead baery / or installed

incorrectly.

Loose electrode wire or switch

terminal wires.

Wrong replacement igniter.

Improper gap at electrode p.

Liing ames on burner.

Replace with heavy duty baery.

Check that electrode wire is rmly pushed onto the

terminal on the back of the igniter. Check that the

lead wires from the module to the ignion switch (if

equipped) are rmly pushed onto their respecve

terminals.

One spark systems must use a one spark igniter.

Ensure that the collector box is ght and the gap

between the electrode end and the collector box is

between 1/8” - 3/16” (3mm-5mm). The gap can be

adjusted by bending the box in or out.

Close air shuer slightly - see previous problem.

Humming regulator. Normal occurrence on hot days. This is not a defect. It is caused by internal vibraons in

the regulator and does not aect the performance or

safety of the gas grill. Humming regulators will not be

replaced.

Burners will not cross light

each other.

Plugged ports along back of

burner.

Clean burner ports. See burner maintenance

instrucons.

“Paint” appears to be

peeling inside lid or hood.

Grease build-up on inside

surfaces.

This is not a defect. The nish on the lid and hood is

porcelain, and will not peel. The peeling is caused by

hardened grease, which dries into paint-like shards,

that ake o. Regular cleaning will prevent this. See

cleaning instrucons.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Napoleon PRESTIGE II 750 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info