Bedienungsanleitung Napoleon Triumph 410 (Seite 4 von 56) (Deutsch, Englisch, Französisch)

637885

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Correct Disposal Of This Product

This marking indicat

es that this product should not be disposed with other household wastes throughout the

EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle

it responsibly to promote the sustainable reuse of material resources. To return your used device, please use

the return and collecon systems or contact the retailer where the product was purchased. They can take

this product for environmental safe recycling.

Gas Cylinder

Use only gas cylinders, which mee

t naonal and regional codes. The minimum cylinder size for butane units

is 13kg, and for propane units is 6kg. Ensure that the cylinder can provide enough fuel to operate the appli-

ance. If in doubt, check with your local gas supplier.

• Use cauon when handling the cylinder valve.

• Never connect a cylinder, which does not meet local codes.

WAR

NING!

Ensure that the hose is r

outed to maintain proper clearance to the underside of the unit.

Hoses that contact high temperature surfaces may melt and leak, causing a re.

Cylinder Connecon: Ensure that the gas regulator hose is kink free. Remove the cap or plug from the cylin-

der fuel valve. Tighten regulator to cylinder valve. Leak test all joints prior to using the barbecue. A leak test

must be performed annually, and each me a cylinder is hooked up, or if a part of the gas system is replaced.

NING!

• Do not rout

e hose underneath drip pan.

• Do not route hose between space in boom shelf and back panel.

• Do not route hose over top of back panel.

• Ensure all connecons are ghtened using two wrenches. Do not use Teon tape or pipe dope on any

hose connecon.

• Ensure the hose does not contact any high temperature surfaces, or it may melt and leak causing a re.

• Do not use enclosure to store excess hose, as there is a greater chance of the hose contacng a hot sur-

face, it may melt and leak causing a re.

www.napoleongrills.com

Gas Hose

• If the hose and regula

tor are not included by the manufacturer, then only hoses and regulators which

meet naonal and regional codes are to be used.

• Ensure that the hose does not come into contact with grease, other hot drippings, or any hot surfaces on

the appliance.

• Check hose regularly. In the case of rips, melng or wear, replace hose before using the appliance.

• The recommended hose length is 0.5m. The hose must not be longer than 1.5m.

• Ensure that the hose is twist and kink free when installed.

• Replace the hose before expiry date printed on the hose.

All cylinders must be placed outside the enclosure (under the right side shelf) on level ground.

connected to the appliance may be stored in the enclo-

must not be stored in the enclosure, or in close proximity of

to extreme heat or direct sunlight.

Only cylinders

sure, or close to the appliance. Spare cylinders

an operang unit. Cylinders must not be exposed

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Napoleon Triumph 410 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info