Bedienungsanleitung Napoleon Triumph 410 (Seite 9 von 56) (Deutsch, Englisch, Französisch)

637885

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

www.napoleongrills.c

Ligh

ts: T

o r

move the lens from the light housing, insert a at screwdriver p between the lens and the

hous

ing and r

ock it g

tly

. Do not touch the halogen bulb. The oil from your ngerps will reduce the

life of the bulb. To clean the lens, rst soak it in hot soapy water, then clean with a rag and non abrasive

cleaner. To reinstall the lens, simply snap it back into the housing.

Tube Burner: The burne

rs are made from heavy wall 304 stainless steel, but extreme heat and a corrosive

envi

ronment can c

ause surface corrosion to occur. This can be removed with a brass wire brush.

CAUTION!

Beware of Spider

Spiders and insects are aracted to the smell of propane and natural gas. The burner is equipped with an

insect screen on the air shuer, which reduces the likelihood of insects building nests inside the burner

but does not enrely eliminate the problem. A nest or web can cause the burner to burn with a so

yellow or orange ame or cause a re (ashback) at the air shuer beneath the control panel. To clean the

inside of the burner, it must be removed from the gas grill: Remove the screw that aaches the burner to

the back wall. Slide the burner back and upwards to remove. Cleaning: Use a exible venturi tube brush

to clean the inside of the burner. Shake any loose debris from the burner through the gas inlet. Check the

burner ports and valve orices for blockages. Burner ports can close over me due to cooking debris and

corrosion, use an opened paperclip or the supplied port maintenance bit to clean them. Drill out blocked

ports using this drill bit in a small cordless drill. The ports are easier to clean if the burner is removed from

the grill, but it can also be done with the burner installed. Do not ex the drill bit when drilling the ports,

as this will cause the drill bit to break. This drill is for burner ports only, not for the brass orices (jets)

which regulate the ow into the burner. Take care not to enlarge the holes. Ensure the insect screen is

clean, ght, and free of any lint or other debris.

Reinstallaon: Reverse the procedure to reinstall the burner. Check that the valve enters the burner when

installing.

WARNING!

Accumulated grease is a r

e hazard.

Drip Pan: Clean the drip pan frequently (every 4 – 5 uses or as oen as required) to avoid grease buildup.

Grease and excess drippings pass through to the drip pan, located beneath the gas grill and accumulate in

the disposable grease tray below the drip pan. To access the disposable grease tray or to clean the drip

pan, slide the drip pan free of the grill. Never line the drip pan with aluminum foil, sand or any other mate-

rial as this could prevent the grease from owing properly. The pan should be scraped out with a puy

knife or scraper. Replace the disposable grease tray every 2 – 4 weeks, depending on gas grill usage. For

supplies, see your Napoleon Gas Grill dealer.

Cleaning The Outer Grill Surface: Do not use abrasive cleaners or steel wool on any painted, porcelain or

stainless steel parts of your Napoleon Grill. Doing so will scratch the nish. Exterior grill surfaces should be

cleaned with warm soapy water while the metal is sll warm to the touch. To clean stainless surfaces, use

a stainless steel or a non-abrasive cleaner. Always wipe in the direcon of the grain. Over me, stainless

steel parts discolor when heated, usually to a golden or brown hue. This discoloraon is normal and does

not aect the performance of the grill. Porcelain enamel components must be handled with addional

care. The baked-on enamel nish is glass-like, and will chip if struck. Touch-up enamel is available from

your Napoleon Grill dealer.

WARNING!

Hose: Check for abrasions, melng, cuts, and cr

acks in the hose. If any of these

condions exist, do not use the gas grill. Have the part replaced by your Napoleon Gas Grill dealer or

qualied gas installer.

WARNING!

When reinstalling the burner a

er cleaning it is very

important that the valve/orice enters the burner tube before lighng your

gas grill. If the valve is not inside the burner tube a re or explosion could

occur.

Aluminum Casngs: Clean casngs periodic

ally with warm soapy water. Aluminum will not rust, but high

temperatures and weathering can cause oxidaon to occur on aluminum surfaces. This appears as white

spots on the casngs. To renish these areas, clean rst and sand lightly with ne sandpaper. Wipe the

surface to

remov

e any residue and paint with high temperature barbecue paint. Protect surrounding

areas from over-spray. Follow the manufacture’s direcons for curing.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Napoleon Triumph 410 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info