Bedienungsanleitung Nautilus R618 (Seite 29 von 46) (Englisch)

671433

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

Power-Up / Idle Mode

The Console will enter Power-Up / Idle Mode if it is plugged into a power source, any button is pushed, or if it receives a

signal from the RPM sensor as a result of pedaling the machine.

Auto Shut-Off (Sleep Mode)

IftheConsoledoesnotreceiveanyinputinapproximately5minutes,itwillautomaticallyshutoffunlessinDemonstration

mode.

Push any button to start (wake up) the Console. If your machine is in Demonstration mode, hold down the PAUSE/END

button and Left button together for 3 seconds.

Note: The Console does not have an On/Off switch.

Initial Setup

Duringtherstpower-up,theConsoleshouldbesetupwiththedate,timeandyourpreferredmeasurementunits.

1. Date:PushtheIncrease/Decreasebuttonstoadjustthecurrentlyactivevalue(ashing).PushtheLeft/Rightbuttons

to change which segment is the currently active value (month / day / year).

2. Push OK to set.

3. Time:PushtheIncrease/Decreasebuttonstoadjustthecurrentlyactivevalue(ashing).PushtheLeft/Rightbuttons

to change which segment is the currently active value (hour / minute / AM or PM).

4. Push OK to set.

5. UnitsofMeasurement:PushtheIncrease/Decreasebuttonstoadjustbetween“MILES”(ImperialEnglish)or“KM”

(metric).

6. PushOKtoset.TheConsolegoesbacktothePower-Up/IdleModescreen.

Note: Toadjusttheseselections,consultthe“ConsoleSet-UpMode”section.

Quick Start ( Manual ) Program

The Quick Start ( Manual ) program lets you start a workout without entering any information.

During a Manual Workout, each column represents a 2 minute time period. The active column will advance across the

screenevery2minutes.Iftheworkoutlastsformorethan30minutes,theactivecolumnisxedonthefarthestcolumnon

the right and pushes the previous columns off the display.

1. Sit on the machine.

2. PushtheUserbuttontoselectthecorrectUserprole.IfyoudonothaveaUserprolesetup,youcanselectaUser

prolethathasnocustomizeddata(defaultvaluesonly).

3. Push the QUICK START button to start the Manual program.

4. To change the resistance level, push the Resistance Increase/Decrease buttons. The current interval and future

intervalsaresettothenewlevel.ThedefaultManualresistancelevelis4.Thetimewillcountupfrom00:00.

Note: IfaManualworkoutisperformedformorethan99minutesand59seconds(99:59),theunitsforTimewillshiftto

hours and minutes ( 1 hour, 40 minutes ).

5. When done with your workout, stop pedaling and push PAUSE/END to pause the workout. Push PAUSE/END again

to end the workout.

Note: The workout results are recorded to the current User Profile.

User Profiles

The Console lets you store and use 4 User profiles. The User profiles automatically record the workout results for each

workout, and allow the workout data to be reviewed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nautilus R618 Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info