Bedienungsanleitung Navigon p 9611 porsche (Seite 7 von 25) (Englisch)

162371

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

62 – 63

6. Touch the SETTINGS button in the START

DISPLAY in order to adjust the language and

brightness settings or to calibrate the

touchscreen.

2.3 Turning the device on and off, Reset

General information on switching on and off

In order to minimize battery charge loss while

reducing switch-on time, the device also has a

standby mode.

Switching on

To switch on the device, press and hold the on/off

button down for 1.5 seconds. The device powers up

within 2 seconds from standby mode, or within 35

seconds from off mode.

Switching off

You can switch the device to standby mode by

pressing the on/off button briefly (recommended).

To switch to off mode, you must press and hold the

on/off button for 4 seconds. In this mode, the

device requires no power, but cannot be charged.

Reset

Should the device show signs of malfunction, then

please carry out a reset. To do this, press the reset

button on the back of the device. [page 59] The

device will then restart (warmstart). If this does not

work, or the malfunction persists, please carry out a

hardware reset (Coldstart). To do this, press and

hold the on/off button for 4 seconds when the

device is switched on. Wait a few seconds and then

switch on the device using the on/off button.

Note: you can get information regarding

changing individual settings by touching the

HELP button.

2.4 Navigation with GPS

GPS is based on a total of 24 satellites that circle the

earth and, in doing so, are constantly transmitting

their position and the current time. The GPS receiver

receives this data and calculates its own geographi-

cal position on the basis of the information

broadcast by the various satellites.

In order to determine position precisely, it is necessary

to obtain the data from at least three satellites. With

the data from 4 or more satellites, the altitude above

sea level can also be ascertained. Position is accurate

within 3 metres.

Once P´ 9611 has determined your position, this

position can be used as a starting point for a route

calculation.

The map data on your navigation device includes the

geographical coordinates of all digitally recorded

points of interest, streets and places. Using this

data, the system is able to calculate a route from any

given starting point to a destination.

The calculation of the current position and its

representation on the map takes place once every

second, so your current position is always shown on

the map.

2.5 Important safety information

In your own interest, read the following notices and

safety information carefully before starting up your

navigation system.

2.5.1 Navigation safety information

Use the navigation system at your own risk.

Caution !

– To prevent accidents, do not program the

navigation system while driving.

– Only look at the touchscreen when it is safe

to do so and the traffic situation allows it.

– Traffic regulations have priority over any

instructions from the navigation system.

02 Prior to commissioning

Fig. 4

Fig. 5

Fig. 6

Fig. 7

Fig. 8

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Navigon p 9611 porsche Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info