Bedienungsanleitung Navman 8084 (Seite 24 von 116) (Englisch)

663846

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

NAVMAN 8120/8084 Installation and Operation Manual24

position, and the latitude and longitude has a

cursor symbol to show this:

36° 29.841’ N or S Latitude

175° 09.012’ E or W Longitude

3-2-1 Chart modes

The Chart has two modes:

Centre on boat mode

To switch to centre on boat mode in the chart

window, press

ESC

. The boat is at the centre

of the chart. As the boat moves through the

water, the chart automatically scrolls to keep

the boat in the centre of the chart. The cursor

(see below) is turned off.

Cursor mode

The keys

and are called cursor keys.

To switch to cursor mode in the chart window,

hold down a cursor key. The cursor

appears

and moves away from the boat:

Press the key which points in the direction

that the cursor will move, for example press

to move the cursor down.

Press midway between two of the cursor

keys to make the cursor move diagonally.

Hold a cursor key down to make the cursor

move continuously across the window.

In Cursor mode:

The distance (

DST) and bearing ( BRG) of

the cursor from the boat are displayed at

the bottom corner of the window.

The chart does not scroll as the boat

moves.

If the cursor reaches the edge of the

window, the chart will scroll.

For example, hold down

to move the

cursor to the right side of the window and

the chart will scroll to the left.

3-2-2 Latitude and longitude

Latitude and longitude can be displayed in

the data header. The window is degrees and

minutes to three decimal places, about 2 m

(6 ft) resolution. Normally the position is the

boat’s position, and the latitude and longitude

has a boat symbol to show this:

36° 29.637’ N or S Latitude

175° 09.165’ E or W Longitude

If the cursor has been moved in the last ten

seconds, then the position is the cursor’s

3-2-3 Chart scale

Press to zoom in and display a smaller area

of the chart in more detail. Press

to zoom

out and display a bigger area in less detail.

The chart scale is displayed at the top left of

the chart:

3-2-4 Chart symbols and information

The chart shows many kinds of symbols,

such as waypoints, ports, marinas, buoys

and beacons. If necessary, press or

to choose a chart scale where the symbol is

displayed.

To see stored information about a symbol:

1 Either move the cursor to the symbol on

the chart and wait two seconds

or use Find to move the cursor to a symbol

for a port or service (see section 3-2-5).

2 A window appears at the bottom of the

display with some information about the

symbol.

3 To see more detail about a symbol or a list

of associated items for the symbol, press

ENTER

i Select an item to display. If there are

more items than will fit on the window,

press

or to scroll up or down.

Select a camera icon to display a photo

of the item. If the photo is too big to fit

on the window, press

, , or to

scroll the photo.

Select Tide Station to display a tide

chart for the position (see section 14).

WARNING

When reading the boat position, make

sure the position is not the cursor

position.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Navman 8084 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info