512548
14
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
REPEAT 3100 Installation and Operation Manual
NAVMAN
14
Appendix C - Troubleshooting
This troubleshooting guide assumes that you have
read and understood this manual.
It is possible in many cases to solve difficulties
without having to send the unit back to the
manufacturer for repair. Please follow this
troubleshooting section before contacting the
nearest NAVMAN dealer.
There are no user serviceable parts. Specialized
methods and testing equipment are required to
ensure that the unit is reassembled correctly and is
waterproof. Repairs to the unit must only be carried
out by a service centre approved by Navman NZ
Limited. Users who service the unit themselves will
void the warranty.
More information can be found on our website:
www.navman.com
1 Unit will not turn on:
a Fuse blown or circuit breaker tripped.
b Power supply voltage is outside the range
10.5 to 16.5 V DC.
c Power/data cable damaged.
2 Displays dashes (— —) instead of a data
value:
a The REPEAT 3100 has not been installed
with an instrument that can send
compatible data to the REPEAT 3100.
b The instrument that sends compatible data
to the REPEAT 3100 is turned off or the
value is outside the range that the
instrument can display.
c Power/data cable damaged.
3 Values displayed are wrong or erratic:
a The instrument that sends compatible data
to the REPEAT 3100 is not operating
correctly. Refer to the troubleshooting
guide in the instrument’s installation and
operation manual.
b Interference from electrical noise. Review
installation.
4 Unit operates erratically or unexpectedly:
Unit set up incorrectly. Reset to factory
defaults (see section 5-3). Then setup the
unit again (see section 5-2).
5 Unit will only display one item of wind or
NMEA data at a time:
This is normal. Two items are only
displayed in dual mode.
6 An item of NMEA data is not displayed:
Turn the NMEA function on (see section 5-2,
step 2).
7 A NMEA function is not displayed in the NMEA
selection screen (see section 5-2, step 2):
Press
or to scroll through the
available functions. If a function is not
displayed then it means that the REPEAT
3100 is not connected to a compatible NMEA
instrument that outputs that NMEA sentence.
8 The word SIM flashes at bottom, right of
screen, values displayed are unexpected:
a The REPEAT 3100 has simulate turned on
(see section 2-5).
b An instrument sending data to the
REPEAT 3100 has simulate turned on
(see section 2-5).
9 The display fogs:
a Moist air has entered the breathing tube at
the rear of the unit. Air the boat or run unit
with backlight fully on.
b Water has entered the breathing tube.
Return unit for service.
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Navman Repeat 3100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Navman Repeat 3100

Navman Repeat 3100 Bedienungsanleitung - Deutsch, Holländisch, Italienisch, Schwedisch, Finnisch - 64 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info