Bedienungsanleitung Navman Tracker 5605 (Seite 62 von 68) (Englisch)

512559

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

TRACKER 5505/5505i/5605 Installation and Operation Manual

NAVMAN

1-1 The TRACKER won’t turn on:

a The TRACKER is designed to operate on

a 12/24 volt battery system, where the

voltage may vary from 10.5 to 32 volts. If

an excessive voltage is supplied, a fuse will

be tripped, turning the display unit off.

Check the fuse.

b Check that the power cable connector

at the back of the display unit is securely

plugged in and the collar is locked in place.

The collar must be secure for watertight

connection.

c Measure the battery voltage while the

battery is under load - turn on some

lights, radio or other electrical equipment

connected to the battery. If the voltage is

less than 10 volts:

- the battery terminals or wiring on the

terminals may be corroded.

- the battery may not be charging

correctly or may need replacing.

d Inspect the power cable from end to end

for damage such as cuts, breaks, squashed

or trapped sections.

e Ensure that the red wire is connected to the

positive battery terminal and the black wire

to the negative battery terminal. If wired for

the Auto Power option, ensure the yellow

wire is connected to the ignition circuit.

Also check the boat’s main switch circuit

(see section 15-4).

This troubleshooting guide is written with

the assumption that the user has read and

understood the relevant sections in this

manual.

It is possible in many cases to solve difficulties

without having to send the display unit back to

the manufacturer for repair. Please follow this

troubleshooting section before contacting the

nearest NAVMAN dealer.

There are no user serviceable parts. Specialized

methods and testing equipment are required

to ensure that the display unit is reassembled

correctly and is waterproof. Users who service

the product themselves will void the warranty.

Repairs to the product may only be carried out

by a service centre approved by NAVMAN. If the

product must be sent into a service centre for

repair, it is essential to send in the transducer(s)

at the same time.

More information can be found on our Website:

www.navman.com.

f Check for corrosion on the power cable

connector and clean or replace if required.

g Check fuses that are placed in line with the

power cable. A fuse can be blown despite

appearing to be good or the fuse may be

corroded. Test the fuse or replace it with a

fuse known to be good.

1-2 The TRACKER won’t turn off:

The TRACKER may have been wired for

Auto power. In this case, the TRACKER

cannot be turned off while the ignition

power is on (see section 2-3).

1-3 If the TRACKER beeps when turned on but

nothing is displayed:

The TRACKER may be operating, but the

backlight settings may have been set too

low (see section 2-4).

1-4 The wrong language is displayed:

See section 14-1.

Appendix B - Troubleshooting

B-1 General Problems

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Navman Tracker 5605 Seite 62

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Navman Tracker 5605

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info