170484
190
Zoom out
Zoom in
Vorherige Seite
1/266
Nächste Seite
User Guide
190
www.nec-computers.com
If only the supervisor password is set, you:
Must enter the supervisor password to enter BIOS Setup.
Must enter the supervisor password to boot the server if Password on Boot is
enabled in the BIOS Setup.
Must enter the supervisor password to exit secure mode.
If both passwords are set, you:
May enter the user password to enter BIOS Setup. However, you will not be able
to change many of the options.
Must enter the supervisor password if you want to enter BIOS Setup and have
access to all of the options.
May enter either password to boot the server if Password on Boot is enabled in
either the BIOS Setup.
May enter either password to exit secure mode.
Secure Mode
Configure and enable the secure boot mode by using the BIOS Setup (See “BIOS Setup
Utility” on page 238).
When secure mode is in effect:
You can boot the server and the operating system will run, but you must enter the
user password to use the keyboard or mouse.
You cannot turn off the server power or reset the server from the front panel
switches.
Secure mode has no effect on functions enabled via remote server management or
power control via the watchdog timer.
Taking the server out of secure mode does not change the state of system power. That
is, if you press and release the power switch while secure mode is in effect, the system
will not be powered off when secure mode is later removed. However, if the front panel
power switch remains depressed when secure mode is removed, the server will be
powered off.
Software Security Features
The table below lists the software security features and describes what protection each
offers. In general, to enable or set the features listed here, run the BIOS Setup and go to
the Security Menu (See BIOS Security Features Menu” on page 250).
The table also refers to the Setup utility (See
BIOS Setup Utility” on page 238).
Note: Some of the measures listed below may not be
available on your server.
190

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Nec express5800 tm800 nl wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info