654027
137
Zoom out
Zoom in
Vorherige Seite
1/155
Nächste Seite
127
8. Appendix
1 Troubleshooting
Thissectionhelpsyouresolveproblemsyoumayencounterwhilesettinguporusingtheprojector.
Indicator Messages
Power Indicator
Indicator Condition ProjectorCondition Note
Off The main power is off
Blinking light Blue
0�5 sec On,
0�5 sec Off
The projector is getting ready to turn on� Wait for a moment�
2�5 sec On,
0�5 sec Off
Off Timer is enabled�
Steady light Blue The projector is turned on�
Orange [NORMAL] is selected for [STANDBY MODE]
Red [POWER-SAVING] is selected for [STANDBY
MODE]
Status Indicator
Indicator Condition ProjectorCondition Note
Off
Normal or Standby ([POWER-SAVING] for
[STANDBY MODE])
Blinking light Red
1 cycle (0�5 sec
On, 2�5 sec Off)
Lamp cover error or lamp housing error Replace the lamp cover or lamp housing correctly
2 cycle (0�5 sec
On, 0�5 sec Off)
Temperature error The projector is overheated� Move the projector to
a cooler location�
3 cycle (0�5 sec
On, 0�5 sec Off)
Power error Power unit is not working properly Contact your
dealer
4 cycle (0�5 sec
On, 0�5 sec Off)
Fan error Fans will not work correctly
6 cycle (0�5 sec
On, 0�5 sec Off)
Lamp error Lamp fails to light� Wait a full minute and then turn
on again�
9 cycle (0�5 sec
On, 0�5 sec Off)
[DYNAMIC CONTRAST] error Dynamic Contrast function is not working properly�
Contact your dealer
Orange
1 cycle (05 sec
On, 2�5 sec Off)
Network conflict
Both the built-in wired LAN and the wireless LAN can-
not be connected to the same network at the same
time�
To use both built-in wired LAN and wireless LAN at
the same time, connect them to different networks�
Green Re-firing the lamp (The projector is cooling
down�)
The projector is re-firing�
Wait for a moment�
Steadylight
Green
Standby ([NORMAL] for [STANDBY MODE])
Orange
CONTROL PANEL LOCK is on� You have pressed cabinet button when Control
Panel Lock is on�
CONTROL ID error Remote control ID and projector ID are not
matched�
Lamp Indicator
Indicator Condition ProjectorCondition Note
Off Normal
Blinking light Red
Lamp has reached its end of life� Lamp replace-
ment message will be displayed�
Replace the lamp�
Steady light Red Lamp has been used beyond its limitThe projector
will not turn on until the lamp is replaced�
Replace the lamp�
Green [ECO MODE] is set to [AUTO ECO], [ECO1], or
[ECO2]
Over-TemperatureProtection
Ifthetemperatureinsidetheprojectorrisestoohigh,theover-temperatureprotectorwillautomaticallyturnoffthelamp
withtheSTATUSindicatorblinking(2-cycleOnandOff.)
Shouldthishappen,dothefollowing:
• Unplugthepowercordafterthecoolingfansstop.
• Movetheprojectortoacoolerlocationiftheroomwhereyouarepresentingisparticularlytoowarm.
• Cleantheventilationholesiftheyarecloggedwithdust.
• Waitabout60minutesuntiltheinsideoftheprojectorbecomescoolenough.
137

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Nec NP-M420X wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Nec NP-M420X

Nec NP-M420X Bedienungsanleitung - Deutsch - 155 seiten

Nec NP-M420X Kurzanleitung - Holländisch, Dänisch, Polnisch, Türkisch, Norwegisch, Finnisch - 6 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info