Bedienungsanleitung Nec np510 (Seite 82 von 114) (Englisch)

216187

Zoom out

Zoom in

Vorherige Seite

1/114

Nächste Seite

5. Using On-Screen Menu

SelectingCommunicationSpeed[COMMUNICATIONSPEED]

ThisfeaturesetsthebaudrateofthePCControlport(D-Sub9P).Itsupportsdataratesfrom4800to19200bps.The

defaultis19200bps.Selecttheappropriatebaudrateforyourequipmenttobeconnected(dependingontheequip-

ment,alowerbaudratemayberecommendedforlongcableruns).

NOTE:Yourselectedcommunicationspeedwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.

SettingIDtotheProjector[CONTROLID]

(AvailableonlywhentheoptionalremotecontrolNP02RCisused)

YoucanoperatemultipleprojectorsseparatelyandindependentlywiththesingleremotecontrolthathastheCONTROL

IDfunction.IfyouassignthesameIDtoalltheprojectors,youcanconvenientlyoperatealltheprojectorstogether

usingthesingleremotecontrol.Todoso,youhavetoassignanIDnumbertoeachprojector.

CONTROL ID NUMBER .......Select a number from 1 to 254 you wish to assign to your projector.

CONTROL ID

.......................Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID set-

ting.

NOTE:

• Selecting[ON]for[CONTROLID]willmaketheremotecontrolsuppliedwiththeprojectorinoperable.Thebuttonsontheprojector

cabinetcanbeused.NeithercanyouoperatetheprojectorbyusingtheoptionalremotecontrolNP01RCthatdoesnothasthe

CONTROLIDfunction.

• Yoursettingwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.

•PressingandholdingtheENTERbuttonontheprojectorcabinetfor10secondswilldisplaythemenuforcancelingtheControl

ID.

AssigningorChangingtheControlID

1. Turn on the projector.

2. Press the ID SET button on the remote control (NP02RC).

The CONTROL ID screen will be displayed.

If the projector can be operated with the current remote control ID, the [ACTIVE] will be displayed. If the projector

cannot be operated with the current remote control ID, the [INACTIVE] will be displayed. To operate the inactive

projector, assign the control ID used for the projector by using the following procedure (Step 3).

3. Press one of numeric keypad buttons while pressing and holding the ID SET button on the remote control

(NP02RC).

Example:

To assign “3”, press the “3” button on the remote control.

No ID means that all the projectors can be operated together with a single remote

control. To set “No ID”, enter “000” or press the CLEAR button.

TIP:TherangeofIDsisfrom1to254.

4. Release the ID SET button.

The updated CONTROL ID screen will be displayed.

NOTE:TheIDscanbeclearedinafewdaysafterthebatteriesarerundownorremoved.

OFF ON

COMPUTER

VIDEO S-VIDEO

VIEWER

NETWORK

HDMI

PIP

MAGNIFY

VOLUME

PICTURE

LAMP MODE

ASPECT

AV-MUTE

3D REFORM

FREEZE

ID SET

LENS SHIFT

FOCUS

/ZOOM

HELP

PAGE

L-CLICK

R-CLICK

EXIT

COMPONENT

AUTO ADJ.

ENTER

DOWN

POWER

123

1 32

4 65

7 98

CLEAR