Bedienungsanleitung Nec V230 (Seite 6 von 99) (Englisch)

537849

Zoom out

Zoom in

Vorherige Seite

1/99

Nächste Seite

Important Information

- If the projector does not operate normally when you follow the instructions described in this user's manual.

- If the projector has been dropped or the cabinet has been damaged.

- If the projector exhibits a distinct change in performance, indicating a need for service.

• Disconnectthepowercableandanyothercablesbeforecarryingtheprojector.

• Turnofftheprojectorandunplugthepowercablebeforecleaningthecabinetorreplacingthelamp.

• Turnofftheprojectorandunplugthepowercableiftheprojectorisnottobeusedforanextendedperiodof

time.

• WhenusingaLANcable(V300X/V260Xonly):

For safety, do not connect to the connector for peripheral device wiring that might have excessive voltage.

CAUTION

• Donotusethetilt-footforpurposesotherthanoriginallyintended.Misusessuchasusingthetiltfoottocarryor

hang (from the wall or ceiling) the projector can cause damage to the projector.

• Donotsendtheprojectorinthesoftcasebyparceldeliveryserviceorcargoshipment.Theprojectorinsidethe

soft case could be damaged.

• Select[HIGH]inFanmodeifyoucontinuetousetheprojectorforconsecutivedays.(Fromthemenu,select

[SETUP]→[OPTIONS(1)]→[FANMODE]→[HIGH].)

• DonotturnofftheACpowerfor60secondsafterthelampisturnedonandwhilethePOWERindicatorisblink-

ing green.

Doing so could cause premature lamp failure.

• PartsoftheprojectormaybecometemporarilyheatediftheprojectoristurnedoffwiththePOWERbuttonorif

the AC power supply is disconnected during normal projector operation.

Use caution when picking up the projector.

Remote Control Precautions

• Handletheremotecontrolcarefully.

• Iftheremotecontrolgetswet,wipeitdryimmediately.

• Avoidexcessiveheatandhumidity.

• Donotheat,takeapart,orthrowbatteriesintore.

• Ifyouwillnotbeusingtheremotecontrolforalongtime,removethebatteries.

• Ensurethatyouhavethebatteries'polarity(+/–)alignedcorrectly.

• Donotusenewandoldbatteriestogether,orusedifferenttypesofbatteriestogether.

• Disposeofusedbatteriesaccordingtoyourlocalregulations.

Lamp Replacement

• Usethespeciedlampforsafetyandperformance.

• Toreplacethelamp,followallinstructionsprovidedonpage70.

• Besuretoreplacethelampwhenthemessage[THE LAMP HAS REACHED THE END OF ITS USABLE LIFE.

PLEASE REPLACE THE LAMP.] appears. If you continue to use the lamp after the lamp has reached the end

of its usable life, the lamp bulb may shatter, and pieces of glass may be scattered in the lamp case. Do not touch

them as the pieces of glass may cause injury.

If this happens, contact your dealer for lamp replacement.

A Lamp Characteristic

The projector has a high-pressure mercury lamp as a light source.

A lamp has a characteristic that its brightness gradually decreases with age. Also repeatedly turning the lamp on

and off will increase the possibility of its lower brightness.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nec V230 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nec V230

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info