Bedienungsanleitung Nedis WIFIFNH10CBK (Seite 4 von 36) (Alle Sprachen)

726140

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Quick start guide

Electric fan heater WIFIFNH10CBK

For more information see the extended manual

online: ned.is/wifnh10cbk

Intended use

The Nedis WIFIFNH10CBK is an electric fan heater used for heating

rooms.

The product is exclusively intended as a fan heater for domestic,

indoor use.

Any modication of the product may have consequences for safety,

warranty and proper functioning.

Parts list (Image A)

Control panel

Air outlet grid

Handle

Air inlet grid

Power switch

Cord

Plug

Safety instructions

WARNING

• Only use the product as described in this manual.

• Any other use, may cause re, electric shock, and/or injury to

persons and may void the warranty.

• Any use of not recommended attachment or accessory may

cause injury to persons, or damage.

• Do not use the product if a part is damaged or defective.

Replace a damaged or defective device immediately.

• Do not disassemble or try to repair the product.

• Do not drop the product and avoid bumping.

• This product may only be serviced by a qualied technician for

maintenance to reduce the risk of electric shock.

• Make sure that the electrical supply in your area matches a

voltage of 220 – 240 VAC and a frequency of 50 Hz.

• Make sure that no other high current appliances are plugged

into the same circuit with your product. Overloading may occur.

• Disconnect the product from the power outlet and other

equipment if problems occur.

• Do not expose the product nor the cord to water, any other

liquid or moisture.

• Do not use the product where splashing of water might occur

e.g. bathrooms, swimming pools or close to a washbowls.

• The product is intended for indoor, domestic use only.

• Fully extend the power cord and make sure the power cord does

not contact the product.

• Do not cover the power cord by e.g. carpets, rugs or furniture.

• Ensure people do not trip over the cord.

• Only plug the cable into a wall outlet. Do not use extension

cords.

• Do not use the product when the cord or plug is damaged.

• Turn o the main power switch before unplugging the power cord.

• Do not unplug the product by pulling on the cable. Always

grasp the plug and pull.

• Do not let children play with parts of packaging such as plastics

bags, because of danger of suocation.

• Close supervision is necessary when the product is used by or

near children, animals or inrm persons. Do not allow children

to play with it or touch it.

• Keep the product out of reach from children, inrm persons or

animals.

• Do not leave the product unattended when switched on.

• Do not use the product in rooms where ammable liquids or

gases are used or stored.

• An area of one meter around the product has to be free from

animals and any combustible materials, such as curtains and

bedding or walls. Do not point the outlet at any of these.

• Do not obstruct or cover the product’s air inlet or outlet grid.

• Do not place any objects on the product.

• Do not locate the product immediately below a power outlet.

• Do not move the product during operation.

• After use only transport the product by using the handle.

• Only handle the product with dry hands. Handling with wet

hands might cause an electric shock.

• Switch o and unplug the product when not in use or before

maintenance.

• Do not pull the power cable over sharp edges.

Turning on the heater

1. Insert the plug into a power outlet.

2. Then turn on the main power switch at the bottom of the rear

side of the heater.

Now the heater is in “stand-by” mode, with only the temperature

indicator shown.

Use the control panel (Image B)

Display

2 High power indicator

3 Low power indicator

4 Fan indicator

5 On/o button

6 Power button

7 Timer button

8 LED indicator

9 Swing indicator

q Time indicator

w Temperature indicator

e + button

r - button

t Swing button

On/o: press to waken the product from stand-by mode.

4 will light up.

Press again to change back to stand-by mode. The fan

will continue to turn for 30 to 60 seconds to cool down

the heater. During this period B

4 ashes.

Press to change between low power to high power

heating or fan only. B

3 and/or B2 will light up.

WIFIFNH10CBK_MAN_COMP19315_v01.indd 4 7-8-2019 12:43:23

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nedis WIFIFNH10CBK Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info