Bedienungsanleitung Neff B58VT64N0 (Seite 18 von 60) (Englisch)

633926

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

en Steam

Notes

■ If your water is very hard, we recommend that you

use softened water.

■ If you use only softened water, you can set your

appliance to the "softened" water hardness range.

■ If you use mineral water, set the water hardness

range to "4 very hard".

■ If you use mineral water, you must only use non-

carbonated mineral water.

1. Touch the ” touch button.

The control panel is automatically pushed forwards.

2. Pull the control panel forwards with both hands and

then push it upwards until it locks into place (Fig. !).

3. Lift the water tank and remove it from the water tank

recess (Fig. ").

4. Fill the water tank with cold water up to the “max.”

mark (Fig. #).

5. Insert the filled water tank (Fig. $). Ensure that the

water tank locks into place behind both holders ‚

(Fig. %).

6. Slowly push the control panel downwards and then

towards the rear until it is closed completely.

The water tank has been filled. You can start

operations with steam.

Refilling the water tank

If the water tank runs dry during a steam operation, a

message appears on the display prompting you to fill

up the water tank.

Notes

■ Steam-assisted operations continue without adding

steam.

■ If the water tank runs dry during operation with the

Dough proving or Reheat settings, operation is

interrupted. Fill the water tank.

1. Open the control panel.

2. Remove and refill the water tank.

3. Insert the filled water tank and close the control

panel.

After every steam operation

:Warning

Risk of scalding!

When you open the appliance door, hot steam can

escape. Steam may not be visible, depending on its

temperature. When opening, do not stand too close to

the appliance. Open the appliance door carefully. Keep

children away.

:Warning

Risk of burns!

The appliance becomes hot during operation. Allow the

appliance to cool down before cleaning.

Caution!

Enamel damage: Do not start any operations when

there is water on the cooking compartment floor. Before

operation, wipe away the water from the cooking

compartment floor.

The remaining water is pumped back into the water

tank after every operation with steam. Then empty and

dry the water tank. Moisture remains in the cooking

compartment. To dry the cooking compartment, you

can either use the "Drying ª" operating mode or dry the

cooking compartment by hand.

Notes

■ Once the appliance has been switched off, the ”

touch button remains lit for a little longer to remind

you to empty the water tank.

■ Remove limescale marks with a cloth soaked in

vinegar, then wipe with clean water and dry with a

soft cloth.

Emptying the water tank

Caution!

Do not dry the water tank in the hot cooking

compartment. This will damage the water tank.

Caution!

Do not clean the water tank in the dishwasher. This will

damage the water tank.

1. Open the control panel.

2. Remove the water tank.

3. Carefully remove the lid of the water tank.

4. Empty and rinse the water tank.

5. Dry all parts with a soft cloth.

6. Place the lid on the water tank and push it down.

7. Insert the water tank and close the control panel.



I

I

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Neff B58VT64N0 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Neff B58VT64N0

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info