Bedienungsanleitung Neff C17KS61H0 (Seite 8 von 28) (Alle Sprachen)

730570

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Safety instructions

R Please read and pay particular attention to the safety information in the instruction manual.

WDanger of electric shock!



hazards, repairs must only be carried out by our customer service personnel.

If the power cord of this appliance is damaged, it must be replaced with a special connection cord,



the mains immediately.

Only an appliance which has been correctly installed according to these installation instructions can

be used safely. Attach loose furniture to the wall with a conventional bracket.



pacemakers or insulin pumps. Persons wearing electronic implants must maintain a minimum

distance of 10 cm from the front of the appliance and from the following parts upon removal: milk

container, milk system, water tank and brewing unit.

Included in delivery (for installation)

a 󰀨

b Installation instructions

c Connecting cable

d Assembly bracket

e Spacer

f 5 fastening screws (silver)

g 2 fastening screws (long/black)

h 2 fastening screws (short/black)

i 1 sleeve (black)

j 2 sleeves (white)

Installing the appliance

Make sure there is adequate aeration. To do this, remove the



be a gap of at least 35 mm between the wall and base of the

unit or the rear panel of the unit situated above. The ventilation

slots and intake openings must not be covered. Also follow the

installation instructions for the appliance situated above or below.

If installing the appliance above a warming drawer, the height of

the recess must be 590 mm. If the appliance is installed directly

under a décor panel, ensure that there is a ventilation slot of at

least 200 cm². The ideal installation height for the fully automatic

󰀨

appliance, is 950 mm.

1 

Do not operate a damaged appliance.

2 Take note of the installation dimensions of the particular

model.

Important: 2 opening angles can be selected for the door.

Depending on the opening angle required, the mounting distance

to the wall should be observed before installation if it is on the left

side.

 

= mounting distance to the wall at least 350 mm on the left.

 

= mounting distance to the wall at least 100 mm on the left.

For this purpose, replace the two limits on the upper and lower

hinges with special accessory no. 00636455.

3 Remove the installation template on the back of the installation

instructions. Place the installation template at the front edge

of the unit and screw on the assembly bracket d as shown

with two fastening screws f. The assembly bracket must be

positioned at the base of the unit and the wall such that no

gap is present.

4 Set the mains switch U to h. Plug the connecting cable c



place). It must not be trapped or kinked. Put the appliance to

be plugged in just on to the edge of the unit.

Important: The distance between the appliance and the back wall

must be at least 35 mm.

5 Push the appliance into the unit until it clicks into place. Check

that the appliance is in the middle. If necessary, align the

appliance. To do so, pull the appliance out a little, remove the

appropriate spacers e and attach to the left side (top and

bottom). Push the appliance into the unit until it clicks into

place.

6 

and open. Remove the drip tray Y. Pull the cover X on the

Pull out the

accessories drawer Z and put to one side.

7 First, screw on the appliance as shown using 2 of each

of the fastening screws f and g as well as 2 sleeves j.

Then screw tight at the top right of the unit using 1 fastening

screw f and sleeve i.

8 Only for the expert





door can be adjusted. To do this adjust the hinges at the top

and the bottom.

I. Adjust the depth of the door by turning the screws V.

II. Remove the hinge dampers at the top and bottom of the

hinges. Turn the screws W to adjust the inclination and the

horizontal position of the doors.

III. 

9 Insert the cover X

screws h.

10 Replace the drip tray Y and accessories drawer Z and close

the appliance door.

Neff C17KS61H0 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Neff C17KS61H0

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info