Bedienungsanleitung Neff C47C62N3 (Seite 27 von 40) (Englisch)

495369

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Replacing the cooking compartment bulb

Heat-resistant 230 V/25 W halogen bulbs with seals are

available from the after-sales service. Please specify the E

number and FD number of your appliance.

: Risk of burns!

Allow the cooking compartment and cooking compartment light

to cool before changing the bulb.

Always use a dry cloth to remove a new halogen bulb from the

packaging, otherwise it will not last as long.

1. Switch off the fuse in the fuse box or unplug at the mains.

2. Turn the cover anti-clockwise to remove.

3. Remove the bulb and replace with a bulb of the same type.

4. Slide the new seals and the clamping ring onto the glass

cover in the right order.

5. Screw the glass cover with the seals back on again.

6. Connect the appliance to the mains and reset the clock.

Never operate the appliance without the glass cover and seals.

Replacing the glass cover or seals

Any damaged glass cover or seals must be replaced. Please

provide the after-sales service with the E number and FD

number of your appliance.

Changing the door seal

If the seal around the outside of the cooking compartment is

faulty, it must be replaced. Replacement seals for your

appliance can be obtained from the after-sales service. Please

specify the E number and FD number of your appliance.

1. Open the appliance door.

2. Pull off the old seal.

3. Push in the new door seal at one point and pull it in all the

way round. The joint must be at the side.

4. Check again that the seal is correctly fitted in the corners.

There is a "pop" noise during cooking Cold/warm effect with frozen food, caused

by the steam

This is normal

When you cook with steam, a lot of steam

is created

The appliance is being automatically cali-

brated

This is normal

When cooking with steam, a great deal of

steam is created again

The appliance is unable to calibrate itself

automatically if cooking times are too

short

Restore the appliance to the factory set-

ting (see section: Basic settings). Then

start

é Steam cooking at 100 °C for

20 minutes

Steam escapes from the ventilation slots

during cooking

This is normal

The appliance is not producing steam

properly

Limescale has formed in the appliance Descale the appliance (see section: Des-

caling).

Error message "E011" appears in the tem-

perature display

A button was pressed for too long or is

jammed

Press the

KJ clock function button to

delete the error message. Press all of the

buttons individually and check if they are

clean

An error message "E..." appears in the

temperature display

Technical fault

Press the

KJ clock function button to

delete the error message, and reset the

clock if necessary. If the error message

appears again, call the after-sales service

The appliance is no longer heating. The

colon is flashing in the clock display. For

example,

ture display

A button combination was actuated Switch off the appliance, press and hold

the

± info button for 3 seconds, then press

and hold the

KJ clock function button for

4 seconds, then press and hold the

± info

button for 3 seconds

Problem Possible cause Notes/remedy

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Neff C47C62N3 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Neff C47C62N3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info