Bedienungsanleitung Neff C57M70N3 (Seite 39 von 104) (Englisch, Spanisch)

495375

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

Error messages

You can take remedial action yourself for some error

messages.

Replacing the cooking compartment bulb

You can replace the cooking compartment bulb. Heat-resistant

25 watt, 240 V halogen bulbs can be obtained from the after-

sales service or from a specialist retailer.

: Risk of electric shock!

Never replace the oven light when the appliance is switched on.

Pull out the mains plug or switch off the appliance at the circuit

breaker in the fuse box.

Note: Always remove the new halogen bulb from the packaging

using a dry cloth. This increases the service life of the bulb.

Method

Note: You must remove the whole appliance in order to replace

the cooking compartment light. Follow the installation

instructions.

1. Unplug the appliance from the mains or switch off the circuit

breaker in the fuse box.

2. Open the appliance door.

Undo the securing screws on the right and left-hand side of

the oven. Follow the installation instructions.

3. Carefully lift out the appliance.

4. Undo the screw from the light cover on the outer left-hand

side wall and remove the cover. (Fig. A) Pull out the halogen

light. (Fig. B).

5. Insert the new halogen bulb (Fig. C)

The microwave does not switch on. The door was not fully closed. Check whether food remains or foreign material

is trapped in the door. Make sure that the seal-

ing surfaces are clean. Check whether the door

seal is twisted.

The

ƒ button has not been pressed. Press the ƒ button.

It takes longer than before for the

food to heat up.

The microwave power setting is too low. Select a higher power setting.

A larger amount than usual has been

placed in the appliance.

Double the amount = almost double the time

The food was colder than usual. Stir or turn the food during cooking

A signal sounds. The two dots in

the display are flashing.

The appliance is in demo mode.

1. Press the °±² button.

2. Press and hold the n button for three sec-

onds.

Demo mode is deactivated.

Problem Possible cause Remedy/information

Error message Possible cause Remedy/Note

Error message "Er1" or "Er4" appears

in the display.

The temperature sensor has failed. Call the aftersales service.

Error message "Er11" appears in the

display. “Button jammed"

The buttons are dirty or the mechanics have

jammed.

Press all buttons several times and, if this

does not help, contact the after-sales ser-

vice.

Error message "Er19" appears in the

display.

There is extreme overheating (possibly a fire

inside). Microwave power setting too high.

Do not open the door. Disconnect from the

mains or switch off the fuse in the fuse box

and allow to cool down.

Error message "Er17", "Er18" or

"E305" appears in the text display.

Technical malfunction. Call the aftersales service.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Neff C57M70N3 Seite 39

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Neff C57M70N3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info