Bedienungsanleitung Neff I79MT86N1 (Seite 6 von 16) (Englisch)

574881

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

en Operating the appliance

Switching over the indicator for circulating-air mode

For circulating-air mode, the electronic control must be

switched over accordingly:

■ The extractor hood must be connected and switched

on.

■ Touch and hold the # and 9 symbols at the same

time, until the ’‹– indicator lights up for the

circulating-air mode "Starter Set". Repeatedly

pressing and holding this button combination

causes the ’–‘ indicator to light up for the

"CleanAir" circulating-air module.

■ Repeatedly pressing and holding this button

combination switches the electronic control back

over to ducted operation (”‚– indicator).

Audible signal

Switching on the audible signal

Touch and hold the # and + symbols at the same time

for approximately three seconds when the fan is

switched on. An audible signal sounds as an

acknowledgement.

Switching off the acoustic signal

Repeat the "Switching on the acoustic signal" process.

Control panel model 2

Setting the fan

Switching on

■ Touch the # symbol.

The fan starts at setting ƒ.

■ Touch + or - to alter the fan speed.

Switching off

Touch the # symbol.

Intensive setting

You can use the intensive setting if there is a large

build-up of odours and fumes/vapours.

Touch the ˜ symbol. ˜ƒ appears on the display. Touch

the - symbol to switch back to the ˜‚ intensive setting.

After approximately six minutes, the electronics

automatically reduce the fan to a lower setting . If you

want to end the intensive setting before the preset time

expires, touch the ˜ symbol.

Automatic mode

Switching on

■ Touch the # symbol.

The fan starts at setting ƒ.

■ Touch the ‘ symbol.

The optimum fan setting ‘‚, ‘ƒ or ‘„ is

automatically set via a sensor.

Switching off

Touch the ‘ or # symbol to switch automatic mode off.

The fan switches off automatically if the sensor no

longer detects a change in the air quality of the room.

Automatic mode can run for a maximum of four hours.

Sensor control

In automatic mode, a sensor in the extractor hood

detects the intensity of the cooking and roasting

odours. Depending on the sensor setting, the fan

automatically switches to another fan setting.

Default sensitivity setting: †

Lowest sensitivity setting: ‹

Highest sensitivity setting: Š

If the sensor control responds too quickly or too slowly,

it can be changed accordingly:

1. Press and hold the ‘ symbol for approximately four

seconds when the fan is switched on. The setting is

displayed.

2. The sensor control setting can be changed by

touching the + or - symbol.

3. To confirm the entry, press and hold the ‘ symbol

for approximately four seconds.

Explanation

Fan on/off

Noise reduction

AirFresh function

Reduces the fan settings

+ Increases the fan settings

Intensive setting

‘

Automatic function

Light on/off/dimming

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Neff I79MT86N1 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Neff I79MT86N1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info