14
Operating procedure
Intensive setting:
Maximum power is obtained at the
intensive setting. It is only required for short
intervals.
❑ Keep pressing the + button until a
ç
appears in the display.
❑ If the intensive setting is not cancelled by
hand, the fan will automatically switch
back to step
} after 10 minutes.
Fan follow-on:
❑ Press the button.
The fan continues to run at step
| for
10 minutes, and at the same time a dot
flashes in the display. After this period
the fan switches off automatically.
Lighting:
❑ The light can be switched on at any
time, even though the fan is switched off.
Light
Fan OFF Reduce fan speed Fan ON and
increase
speed
Intensive
setting
Display for
fan setting
Fan follow-
on
Acoustic signal:
❑ When a button is pressed, this is verified
by an acoustic signal.
Switching the fan ON
❑ Press the + button.
Setting the required fan speed:
❑ Press the + button.
The fan speed is increased by one step.
❑ Press the – button.
The fan speed is reduced by one step.
Switching the fan OFF:
❑ Press the 0 button.
The displayed
{ goes out shortly
afterwards.
Or:
❑ Keep pressing the – button until the fan
switches off.
The displayed
{ goes out shortly
afterwards.
ṇ The most effective method of removing
vapours produced during cooking is to:
❑ Switch the ventilator ON
as soon as you begin cooking.
❑ Switch the ventilator OFF
a few minutes after you have finished
cooking.
RemoteControl:
❑ The hood is equipped with a remote
infrared control with 4 push buttons
which enables to switch on and off the
light, to switch on and off the hood and
to regulate the speeds.
+ Increases the motor speed.
– Reduces the motor speed till it stops.
0 LIGHT.
❑ The infrared remote control is fed by a
battery.
When battery is exhausted it is
necessary:
1. To open the small doo r located on the
underside of the remote-control, sliding it
in thedirectionof thearrow (seeFig.6).
2. Extract the battery and replace it with a
new one having the same c haracteristics.
3. Put the small door of the ba ttery back.
Follow National norms for waste disposal of
batteries.
The fan continues to run at step
| for
10 minutes, and at the same time a dot
flashes in the display. After this period
the fan switches off automatically.
