Operating the appliance en
23
Optical display while
the programme is running *
Optical display while the programme is running
* depending on model
While the programme is running,
an optical display is indicated
on the floor under the appliance door.
If the base panel is pulled forwards
or if the appliance is installed at eye-
level with flush furniture front, the display
is not visible.
Possible settings of the optical
display:
†:‹‚ is set at the factory.
To change the setting:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button `
until •:‹.... is indicated on the digital
display.
4. Release both buttons.
The illuminated display of the
button # flashes.
5. Keep pressing programme
button # until the previously set
value, e.g. †:‹‚, is indicated on the
digital display h †:‹... (for the
optical display).
6. Keep pressing programme
button 3 until the required value,
e.g. †:‹ƒ, is indicated on the digital
display h.
7. Press START button `.
The set value is saved.
8. Close the door.
The following applies to TurboSpeed
20 min.:
During the heating up phase the light
spot * or • *(• = Heating phase) is lit on
the floor. At the end of the heating up
phase the light spot * or p *(p = Load)
flashes, indicating that the appliance
can be opened and loaded.
Remaining running time
display
When the programme is selected, the
programme running time is indicated
on the digital display h. When the
programme has started, the remaining
running time is displayed on the floor
(only for settings †:‹‚ and †:‹ƒ).
The running time is determined during
the programme by the water
temperature, the number of utensils
as well as the degree of soiling
and may vary
(depending on the selected
programme).
Timer programming
Timer programming *
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press button P + until the digital
display h jumps to œ:‹‚.
4. Press P + or – button until the
displayed time corresponds with your
requirements.
5. Press START button `, timer
programming is activated.
†:‹‹ The display is switched off.
†:‹‚ Programme, timer programming,
remaining time, end of programme
and, if required, low water level are
displayed.
†:‹ƒ Same as †:‹‚. Other programme
information is also displayed,
e.g. the symbol for half load §
or glass protection system
active W.