Bedienungsanleitung Neff XB16 (Seite 37 von 56) (Deutsch)

731586

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Trouble shooting en

3Trouble shooting

Tr oubl e s hoot i ng

Faults often have simple explanations. Please read the

notes in the table before calling the after-sales service.

The electronics of your hob are underneath the control

panel. For various reasons, the temperature in this area

may rise sharply.

In order that the electronics do not overheat, the

hotplates are switched off as and when necessary. The

”ƒ, ”…, or ”† display appears alternately with the • or

œ residual heat indicator.

E-report in the displays

When an error message with "E" appears in the display,

e.g. E0111, switch the appliance off and on again.

If it was a one-off error, the display goes out. If the error

message appears again, call the after-sales service and

quote the exact error message.

A flashes in the hotplate indicators

If A flashes in the hotplate indicators when the

appliance is connected to the mains or following a

power cut, the electronics are malfunctioning. To

acknowledge the fault, briefly cover the controls with

your hand.

Display Fault Measure

None The power supply has been disconnected. Check the household fuse for the appliance. Check whether there is a

power cut by trying other electronic appliances.

All displays flash The touch control is wet or an object is resting

on it.

Dry the control or remove the object.

”ƒ Several hotplates have been used over a pro-

longed period at high power settings. To pro-

tect the electronics, the hotplate has been

switched off.

Wait a while. Touch any touch control. When ”ƒ goes out, the electronics

have cooled down sufficiently. You can continue cooking.

”… Despite the switch-off by ”ƒ, the electronics

have become hot again. All hotplates have

therefore been switched off.

Wait a while. Touch any touch control. When ”… goes out, you can con-

tinue cooking.

”†and the heat setting

flash alternately. An

audible signal can be

heard

Warning: There is a hot pan in the area of the

control panel. There is a risk that the electron-

ics will overheat.

Remove the pan. The fault display goes out shortly afterwards. You can

continue cooking.

”†and audible signal There is a hot pan in the area of the control

panel. To protect the electronics, the hotplate

has been switched off.

Remove the pan. Wait a while. Touch any control. When ”† goes out, you

can continue cooking.

”‰ The hotplate was in operation for too long and

has switched itself off.

You can switch the hotplate back on again immediately.

š“ The hotplates do

not heat up

Demo mode is switched on Switching off the demo mode: Disconnect the appliance for 30 seconds

from the power supply (switch off the household fuse or the circuit breaker

in the fuse box). Touch any touch control after 3 minutes. The demo mode

is switched off.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Neff XB16 Seite 37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Neff XB16

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info