Bedienungsanleitung Nestor Martin HARMONY III MF - 39696 (Seite 34 von 44) (Englisch, Holländisch, Französisch, Italienisch, Spanisch)

695255

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

WHAT ARE THE DRAW BACKS OF DAMP WOOD?

Damp wood has far Iess heating power, this lowers the combustion temperature of

the fire therefore, the output. It is difficult to light, burns badly and gives off smoke. Above all

the use of damp wood causes the formation of deposits (tarring and soot staining) in the

chimney flue and the glass door.

WHAT IS TARRING AND SOOT STAINING IN THE CHIMNEY?

When the smoke arrives in the chimney at low temperature, part of the water vapour which

they convey condenses. The heaviest constituants are deposited on the inside of the flue. this is

TARRING. the mixture oxidises in the air and forms brownish patches. That is SOOT STAINING. Four

essential points for avoiding these drawbacks, use dry wood, use a stove designed for wood, connect

it to a chimney with thick walls and of suitable cross-section (size and height), ensure the connecting

pipes are as short as possible. (Horizontal pipes should be no mort than 6" 150mm).

FLUE GAS TEMPERATURE

The most important aspect of stove operation is maintaining a high combustion

temperature. If the combustion of the fuel is at the correct temperature, most of the soots and

tars (hydrocarbons) are burned. These hydrocarbons when not burned can be seen as tar

and creosote deposits on the internal surfaces of the stove, glass and chimney surfaces. To

assist in maintaining these temperatures a surface maunted, stove thermometer is a must.

It is recommended that you heat your stove to at least 400°F before reducing the air

controls. After reloading this procedure should always be carried out. If the wood is not quite

as dry as it should be, to assist for a short period, smokeless coal can be added with the wood

to raise the combustion temperture.

STORAGE TIME FOR WOOD

Wood supplied in ready-cut lengths stored immediately under a ventilated shelter

dries quicker than wood stocked in high piles. Quarters (split wood) dry quicker than round

logs. Wood which is too small to split must be drained, by removing some of the bark. Round

logs left in the open for more than a year end up rotten. The drying time for the fire wood

must be at Ieast 18 months to 2 years. This period can be shortened (12 to 15 months) if the

wood is cut to the right length and immediately stored under a ventilated shelter.

MAINTENANCE OF THE GLASS.

Properly operated, your glass doors will not get coated with thick tar like

conventional stoves. If this does occur you may have to resort to using a glass

cleaner. However by using the correct dry fuels and or smokeless coal , much of

the tar on the glass will burn clean, when the appliance is run at high temperature.

Clean the ceramic glass when cold using commercial products sold for the purpose or

warm water with a drap of vinegar.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nestor Martin HARMONY III MF - 39696 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info