Bedienungsanleitung Nestor Martin S23 (Seite 12 von 48) (Englisch, Spanisch)

571178

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Fig. 18

If you also have an optional draft control (fig. 10),

fitted in the flue above the stove, place the valve

open.

3. Place five or six loosely crumpled sheets of

newspaper in the bottom of the stove. Add a small

amount of dry kindling randomly on the top of the

newspaper. Place a few more loosely crumpled

newspaper on top of the kindling and light the

bottom paper first, then light the top paper.The

upper fire should preheat the chimney and create

an effective draft while the lower fire ignites the

kindling.

It is advisable to leave the door ajar for a few

minutes to facilitate the ignition and avoid

condensation, keeping the glass clean. Never leave

the stove unattended with the door open.

4. Once the fire has started, add increasingly larger

pieces of wood until the fire is actively burning.

5. When the fire is well established, slide the Burn

Type Lever to the top for normal operation with

wood (“A”). Then adjust the Burn Rate Knob to the

desired heat output, either manually or with the

remote control. If you have the Catalytic Hybrid

Woodbox System, close the by-pass to allow the

flue gases pass through the catalyst (Fig. 19) to

achieve the maximum efficiency of the stove.

Protect your hands for such operation. In addition,

if you have an optional draft control (fig. 10), you

can regulate combustion by operating its control.

When burning smokeless coal (Not recommended in

the Catalytic Hybrid Woodbox stoves):

 Always keep the Burn Type Lever in its lower

position ("B"), once the fire is established.

 If your model has a blind grate, remove it, lift

the grate from the bottom of the fire chamber.

Under the grate is the blind grate.

Fig. 19

Fig. 20

3.5. RELOADING THE STOVE

To refuel the stove, first slide the Burn Type Lever to its

mid position, and then rotate the Burn Rate Knob to

maximum. Let the fire “liven up” for about one minute.

Always riddle the grate before putting another load of

smokeless coal to give the initial release of gasses

sufficient air with which to burn.

Open the front door slightly and hold in this position

about 30 seconds or until stove is drafting well. Open

the front door all the way and rake the embers towards

the front of the stove, spreading them evenly. If there

are logs only partially burned, rake these to the front

of stove.

Add fuel. If the fire or coal bed is almost depleted and

a full load of cordwood is added, it may be necessary

to leave the Burn Rate Knob on the high setting for a

while to re-establish a lively fire. Once the fuel is

burning at a brisk rate, slide the Burn Type Lever back

to Position A (wood) or B (coal) and turn the Burn Rate

Knob down to the desired setting.

3.6. OVERNIGHT BURNING

By-pass

By-pass close

Blind grate

Grate

Catalyst

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nestor Martin S23 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nestor Martin S23

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info