Bedienungsanleitung Nestor Martin S23 (Seite 16 von 48) (Englisch, Spanisch)

571178

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

5. CLEANING & MAINTENANCE

WARNING: DO NOT CLEAN STOVE WHILE HOT.

Always keep the area around the unit clean and clear

of furniture and other objects. Keep all furniture and

drapery a minimum of one metre from the stove. Clean

the stoves surface using light strokes of a real bristle

paint brush. Stoves with a cast black finish should never

be cleaned with a cloth as the texture of the paint will

abrade and collect lint from the cloth which will be

almost impossible to remove. Stoves with an enamel

finish should be cleaned with a damp cloth, or very

gentle use of a cleaner recommended for enamel

finishes. In case of condensation, clean the affected

areas before they dry.

Inspect the entire unit frequently for proper operation,

fit and soundness of parts. If any malfunctioning,

cracked, broken, or loose parts or other problems are

noted, contact your dealer or qualified serviceman to

inspect and repair the unit. DO NOT OPERATE THE

UNIT IF INSTALLED OR FUNCTIONING IMPROPERLY.

Seals

Check the fit and seal of the doors and ashpan door

frequently. For proper operation an airtight seal must

be maintained around these openings. If the seal is not

tight, inspect the gasket. If the gasket needs

replacement, contact your dealer. If the gasket is in

good condition, check the closure latch screws; if these

are loose, adjust the door handle (Fig. 24).

Glass

Your stove is fitted with 4 mm ceramic glass. Properly

operated, your glass door will not get coated with thick

tar like conventional stoves. If this does occur, you may

have to resort to using a glass cleaner. However, by

using dry wood, much of the tar on the glass will burn

clean, when the appliance is run at high temperature.

Clean the ceramic glass when cold, using commercial

products sold for this purpose, or warm water with a

drop of vinegar.

The glass used in your stove is ceramic, which can only

be broken due to a strong blow or a bad use. Inspect

the glass regularly. If it detects that it is damaged,

replace the glass using a new glass seal kit immediately.

WARNING: Replacement of damaged glass must be

done with original parts supplied by your dealer. Use

of other materials could cause a safety hazard and

void your warranty.

CAUTION: NEVER OPERATE YOUR STOVE WITH

BROKEN GLASS.

Replacement of the glass:

1. Open the door. Lift off the stove body.

2. Remove the 4 fixing screws and remove the the

glass and old seals.

3. Replace the seals and glass.

4. Install the 4 screws. Do not over tighten the

screws.

Fig. 23

Note: When replacing glass, always replace glass seals

Any maintenance or adjustment, not described in this

manual, must be performed by a trained and

competent technical service engineer.

Door handle adjustment (see Fig. 24)

The stoves are equipped with an adjustable door latch.

For correct operation, the stove door must be airtight

when closed.

To adjust the door handle latch:

1. Loosen the locking nut.

2. Adjust the bolt in or out as required. The

adjustment should be made in such way that

when the handle is in its closed position the door

is airtight and the handle vertical.

3. Re-tighten the locking nut.

Fig. 24

Handle

shaft

Bolt

Latch

Locking nut

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nestor Martin S23 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nestor Martin S23

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info