Bedienungsanleitung Nestor Martin S33 (Seite 4 von 48) (Englisch, Spanisch)

571179

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

1. INTRODUCTION

IMPORTANT! All local regulations, including those

that refer to national or European regulations, must

be applied when installing this device.

The way the stove is installed will decisively affect

safety issues and its correct operation.

It is important to install the stove correctly. For the

correct installation of the stove and chimney, we

recommend the installation be performed by a

professional.

Please read this entire manual before you install and

use your new room heater. Failure to follow

instructions may result in property damage or bodily

injury.

2. INSTALLATION

If your stove is not properly installed, injury or property

damage may result. For your safety, follow the

installation directions. Contact local building or fire

officials about restrictions and installation

requirements in your area.

Warning: Do not connect this unit to a chimney flue

serving another appliance. The unit must be installed

according to all local codes. Installations other than

those specifically covered herein have not been

confirmed by test and are not covered by the

certification

2.1. Chimney.

The chimney is a vital part of your stove installation. A

properly built masonry chimney will assure a

consistent draft under a variety of weather conditions.

(A smoking stove is almost always caused by a chimney

problem)

All chimneys must be installed either according to the

local building codes in the case of a masonry chimney

or according to the chimney manufacturer’s

instructions in the case of a factory-built metal

chimney. See the chimney manufacturers’ instructions

for exact specifications

Existing chimneys must be inspected before installing

your stove. Consult your local building department for

chimney code requirements. A masonry chimney

should have a code approved liner. This liner must not

have broken or missing pieces. Some non-code

masonry chimneys may be brought up to code by being

relined. (Consult your dealer or qualified chimney

sweep.) Factory-built metal chimneys should also be

inspected, first for creosote deposits (which should be

removed), and then for integrity of the stainless steel

liner. Look for obvious bulges in the lining which may

indicate the need to replace that section (use a bright

flashlight). Also inspect the attic to see that the

chimney has proper clearance to combustible framing

members.

The chimney or vent shall be designed and

manufactured to develop a flow sufficient to

completely remove all flue and vent gases to the

outside atmosphere. The venting system shall satisfy

the draft requirements of the connected appliance in

accordance with the manufactures instructions. The

location, section and height of the chimney condition

the draft.

2.1.1. Chimney Height requirements.

We recommend that the chimney be:

1. at least 100 cm higher than the highest part of the

roof opening through which it passes,

2. and at least 60 cm higher than any part of the roof

within 300cm, measured horizontally.

Fig. 1

2.1.2. Draft requirements

The appliance is merely one component of a larger

system. The other equally important component is the

chimney. This is necessary for achieving the required

flow for safety removing unwanted combustion by-

products from the appliance. If the chimney design

does not promote these ends, the system may not

function properly.

The recommended draft requirements for your stove is

no less than –15 pa (-0.048”) and no greater than –25

pa (-0.12”).

OPERATION OF YOUR STOVE WITH A DRAFT GREATER

THAN –30 Pa (-0.14”) CAN POSSIBLY CAUSE DAMAGE

TO THE STOVE AND VOID THE WARRANTY.

2.1.3. Summary of rules

We shall now provide a summary of the rules that

should be followed when building a chimney:

 Use resistant and non-combustible materials

for the connection between the appliance and

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nestor Martin S33 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nestor Martin S33

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info